Unconventional oil and gas reservoirs have broad exploration and development prospects. Fracture parameters and effectiveness evaluation are two of the key tasks for the evaluation of these types of reservoirs. Array acoustic logging can be used for fracture evaluation to compensate for the deficiencies of the image logging fracture evaluation method. Therefore, to develop acoustic logging evaluation methods as well as nondestructive testing methods for fractures, experiments were conducted to study the shear wave transmission in fractured media. Experiment data demonstrate a good correlation between the shear wave attenuation coefficient and fracture width, and the shear wave attenuation coefficients rise logarithmically with the increase in the fracture width for all models with different porosities and distinct dip angles of fractures. The shear wave attenuation coefficient changes relatively faster with the fracture width when the fracture width is within 250 μm. In addition, the shear wave attenuation is affected by the core porosity and fracture dip angle. When the fracture width is constant, the shear wave attenuation caused by the 0° fracture is relatively larger and is obviously greater than that of the fractures at other angles, which is consistent with the existing experimental results. The results of this study can be used to guide further research on amplitude compensation methods for sonic signal transmission in fractured media and fracture evaluation methods.

Horizontal wells are extensively utilized in the development of unconventional reservoirs. However, the logging responses and formation evaluation in horizontal wells can be impacted by factors like anisotropy and tool eccentricity. To investigate the influence of tool eccentricity on acoustic logging response, physical simulation experiments of array acoustic logging were conducted in a scaled borehole formation model under different tool eccentricity conditions. The experimental data were analyzed, and the findings revealed that when the receiver array is parallel to the borehole axis, the P-wave slowness and S-wave slowness remain unaffected by tool eccentricity. However, the amplitudes of the P-wave and S-wave decrease significantly with increasing tool eccentricity, following an approximate negative exponential pattern. Additionally, when the transmitter is centered and the receiver array intersects the borehole axis at an angle, the wave velocities increase significantly with tool eccentricity, with the P-wave velocity showing a faster increase. Conversely, when the transmitter is eccentric and the receiver array intersects the borehole axis at an angle, the wave velocity decreases notably with tool eccentricity, and the P-wave velocity decreases even faster. These findings contribute to a better understanding of the impact of tool eccentricity on array acoustic logging response in horizontal wells and offer guidance for developing correction schemes to address this effect.