Arrival-time picking is a critical step in microseismic data processing, and thus the quality control of arrival results is necessary. Conventional picking methods may be inaccurate or inconsistent due to varied signal-to-noise ratios (SNR) and waveform patterns of the events recorded in different time sections. To address this issue, we propose a quality assessment method based on waveform similarity coefficients to evaluate arrival results and also a global optimization algorithm based on iterative cross-correlation to refine arrival times. The recordings after moveout correction are applied to calculate the intra-event and inter-event waveform coefficients for the quality assessment of arrival results. The residual time differences of intra-event and inter-event traces are calculated sequentially using an enhanced iterative cross-correlation method. In addition, the stacked waveform of each event after the intra-event residual time correction is introduced for global optimization to obtain the inter-event residual time discrepancies. We use both synthetic data and field data to validate the proposed method. The results indicate that the proposed method yields more robust and reliable results. The quality assessment of the optimized arrivals is greatly enhanced compared to the adjusted picks obtained from single event-based processing methods.

Microseismic monitoring data may be seriously contaminated by complex and nonstationary interference noises produced by mechanical vibration, which significantly impact the data quality and subsequent data-processing procedure. One challenge in microseismic data processing is separating weak seismic signals from varying noisy data. To address this issue, we proposed an ambient-noise-assisted multivariate empirical mode decomposition (ANA-MEMD) method for adaptively suppressing noise in low signal-to-noise (S/N) microseismic data. In the proposed method, a new multi-channel record is produced by combining the noisy microseismic signal with preceding ambient noises. The multi-channel record is then decomposed using multivariate empirical mode decomposition (MEMD) into multivariate intrinsic mode functions (MIMFs). Then, the MIMFs corresponding to the main ambient noises can be identified by calculating and sorting energy percentage in descending order. Finally, the IMFs associated with strong interference noise, high-frequency and low-frequency noise are filtered out and suppressed by the energy percentage and frequency range. We investigate the feasibility and reliability of the proposed method using both synthetic data and field data. The results demonstrate that the proposed method can mitigate the mode mixing problem and clarify the main noise contributors by adding additional ambient-noise-assisted channels, hence separating the microseismic signal and ambient noise effectively and enhancing the S/Ns of microseismic signals.

Accurate phase association and arrival time picking are pivotal for reliable microseismic event location and source characterization. However, the complexity of downhole microseismic wavefields, arising from heterogeneous subsurface structures, variable propagation paths, and ambient noise, poses significant challenges to conventional automatic picking methods, even when the signal-to-noise ratio (SNR) is moderate to high. Specifically, P-wave coda energy can obscure S-wave onsets analysis, and shear wave splitting can generate ambiguous arrivals. In this study, we propose a novel multi-channel arrival picking framework based on Constrained Dynamic Time Warping (CDTW) for phase identification and simultaneous P- and S-wave arrival estimation. The DTW algorithm aligns microseismic signals that may be out of sync due to differences in timing or wave velocity by warping the time axis to minimize cumulative distance. Time delay constraints are imposed to ensure physically plausible alignments and improve computational efficiency. Furthermore, we introduce a Multivariate CDTW approach to jointly process the three-component (3C) data, leveraging inter-component and inter-receiver arrival consistency across the entire downhole array. The method is validated against the Short-Term Average/Long-Term Average (STA/LTA) and waveform cross-correlation techniques using field data from a shale gas hydraulic fracturing. Results demonstrate that the proposed algorithm significantly enhances arrival time accuracy and inter-receiver consistency, particularly in scenarios involving P-wave coda interference and shear wave splitting.