The seismic behavior of the proposed precast segmental unbonded posttensioned concrete bridge columns for use in regions of high seismicity was investigated experimentally. Posttensioning tendons were placed in the hollow core of the columns and left unbonded with the surrounding concrete to decrease prestress loss during earthquakes. Bonded mild steel bars continuous across the segment joints, also referred to as energy dissipation (ED) bars, were used to enhance the seismic resistance of the columns. The bars were unbonded at the critical joint to avoid premature low cycle fatigue failure. The objectives of this study were to (1) verify the proposed construction method and seismic detailing for the ED bars and (2) investigate the seismic behavior of the columns with different ED bar ratios and posttensioning forces. Four large-scale specimens were designed and tested with lateral cyclic loading. Test results showed that the proposed construction method and seismic detailing for the ED bars were effectiv...

Compression tests on cylinders were performed to characterize the compressive stress-strain behavior of steel fiber-reinforced concrete (SFRC) with a high reinforcing index. The reinforcing index, defined as the product of the volume fraction and the aspect ratio of the fibers, of steel fibers examined was as high as 1.7. Hooked-end fibers of various lengths and aspect ratios were considered. The test results indicated that a higher reinforcing index was associated with a higher strain at the peak stress and a higher toughness of SFRC, up to a reinforcing index approximately equal to that corresponding to a 2% fiber volume fraction. Adding steel fibers had little effect on the modulus of elasticity and compressive strength of SFRC. Long steel fibers and fibers with a lower aspect ratio resulted in a larger increase of the toughness of SFRC. On the basis of the test results, analytical models of the stress-strain curve in compression and toughness of SFRC with a reinforcing index up to 1.7 are developed.

Prestressing methods were used to realize long-span bridges in the last few decades. For their predictive maintenance, devices and dynamic nondestructive procedures for identifying prestress losses were mainly developed since serviceability and safety of Prestressed Concrete (PC) girders depend on the effective state of prestressing. In fact, substantial long term prestress losses can induce excessive deflections and cracking in large span PC bridge girders. However, old unsolved problematics as well as new challenges exist since a variation in prestress force does not significantly affect the vibration responses of such PC girders. As a result, this makes uncertain the use of natural frequencies as appropriate parameters for prestress loss determinations. Thus, amongst emerging techniques, static identification based on vertical deflections has preliminary proved to be a reliable method with the goal to become a dominant approach in the near future. In fact, measured vertical deflections take accurately and instantaneously into account the changes of structural geometry of PC girders due to prestressing losses on the equilibrium conditions, in turn caused by the combined effects of tendon relaxation, concrete creep and shrinkage, and parameters of real environment as, e.g., temperature and relative humidity. Given the current state of quantitative and principled methodologies, this paper represents a state-of-the-art review of some important research works on determining prestress losses conducted worldwide. The attention is principally focused on a static nondestructive method, and a comparison with dynamic ones is elaborated. Comments and recommendations are made at proper places, while concluding remarks including future studies and field developments are mentioned at the end of the paper.