This study investigates the influence of resistive pre-heating of the feedstock wire (here called hot-wire) on the stability of laser-directed energy deposition of Duplex stainless steel. Data acquired online during depositions as well as metallographic investigations revealed the process characteristic and its stability window. The online data, such as electrical signals in the pre-heating circuit and images captured from side-view of the process interaction zone gave insight on the metal transfer between the molten wire and the melt pool. The results show that the characteristics of the process, like laser-wire and wire-melt pool interaction, vary depending on the level of the wire pre-heating. In addition, application of two independent energy sources, laser beam and electrical power, allows fine-tuning of the heat input and increases penetration depth, with little influence on the height and width of the beads. This allows for better process stability as well as elimination of lack of fusion defects. Electrical signals measured in the hot-wire circuit indicate the process stability such that the resistive pre-heating can be used for in-process monitoring. The conclusion is that the resistive pre-heating gives additional means for controlling the stability and the heat input of the laser-directed energy deposition.

Evaluation of the high-temperature tensile properties of Ti-6Al-4V manufactured by electron beam melting (EBM) and subjected to a low-temperature hot isostatic pressing (HIP) treatment (800 °C) was performed in this study. The high-temperature tensile properties of as-built and standard HIP-treated (920 °C) materials were studied for comparison. Metallurgical characterization of the as-built, HIP-treated materials was carried out to understand the effect of temperature on the microstructure. As the HIP treatments were performed below the β-transus temperature (995 °C for Ti-6Al-4V), no significant difference was observed in β grain width between the as-built and HIP-treated samples. The standard HIP-treated material measured about 1.4×–1.7× wider α laths than those in the modified HIP (low-temperature HIP)-treated and as-built samples. The standard HIP-treated material showed about a 10–14% lower yield strength than other tested materials. At 350 °C, the yield strength decreased to about 65% compared to the room-temperature strength for all tested specimens. An increase in ductility was observed at 150 °C compared to that at room temperature, but the values decreased between 150 and 350 °C because of the activation of different slip systems.

To manufacture almost fully dense components, electron beam powder bed fusion of Ti-6Al-4V is typically combined with post-heat treatment, such as hot isostatic pressing (HIP). The standard HIP treatment performed at 920°C and 100 MPa for 2 h results in coarsening of the microstructure and impacting the yield strength. A low-temperature HIP treatment performed at 800°C and 200 MPa for 2 h resulted in limited coarsening and comparable yield strength to as-built material. A coarser microstructure is detrimental to tensile properties. Tensile testing at different temperatures revealed that thermal activation of different slip systems could possibly affect the elongation behavior, demanding additional investigation. Performing in situ neutron time of flight diffraction during tensile testing provides data to analyze strain evolution and load partitioning in the crystal lattice, which includes the slip planes. A two-phase elastic–plastic self-consistent model has been used to analyze and compare the experimental results. The lattice strain evolution results indicated that the basal slip {0 0 0 2} was activated at 20°C while the pyramidal slip {1 0 $$\overline{1 }$$ 1 ¯ 1} was first activated during loading at 350°C. Load partitioning results showed that the β phase endures higher stresses than the α phase in the plastic regime.