Optimization methods have been widely applied to the aerodynamic design of gas turbine blades. While applying optimization to high-fidelity computational fluid dynamics (CFD) simulations has proven capable of improving engineering design performance, a challenge has been overcoming the prolonged run-time due to the computationally expensive CFD runs. Reduced-order models and, more recently, machine learning methods have been increasingly used in gas turbine studies to predict performance metrics and operational characteristics, model turbulence, and optimize designs. The application of machine learning methods allows for utilizing existing knowledge and datasets from different sources, such as previous experiments, CFD, low-fidelity simulations, 1D or system-level studies. The present study investigates inserting a machine learning model that utilizes such data into a high-fidelity CFD driven optimization process, and hence effectively reduces the number of required evaluations of the CFD model. Artificial Neural Network (ANN) models were trained on data from over three thousand two-dimensional (2D) CFD analyses of turbine blade cross-sections. The trained ANN models were then used as surrogates in a nested optimization process alongside a full three-dimensional Navier–Stokes CFD simulation. The much lower evaluation cost of the ANN model allows for tens of thousands of design evaluations to guide the search of the best blade profiles to be used in the more expensive, high-fidelity CFD runs, improving the progress of the optimization while reducing the required computation time. It is estimated that the current workflow achieves a five-fold reduction in computational time in comparison to an optimization process that is based on three-dimensional (3D) CFD simulations alone. The methodology is demonstrated on the NASA/General Electric Energy Efficient Engine (E3) high pressure turbine blade and found Pareto front designs with improved blade efficiency and power over the baseline. Quantitative analysis of the optimization data reveals that some design parameters in the present study are more influential than others, such as the lean angle and tip scaling factor. Examining the optimized designs also provides insight into the physics, showing that the optimized designs have a lower amount of pressure drop near the trailing edge, but have an earlier onset of pressure drop on the suction side surface when compared to the baseline design, contributing to the observed improvements in efficiency and power.
30 August 2016 in Materials Science and Technology
The Ni60 and SiC–Ni60 composite coatings were successfully obtained by high-frequency inductive cladding on the AISI 1045 steel surface. The influence of SiC nanoparticles on the morphologies, phase composition, micro-hardness, wear resistance and corrosion resistance of the coatings were investigated systematically. An ultrasonic-assisted method was pre-treated for homogenising coating. The performance tests of coatings indicated that high-quality metallurgical bonding was formed under the optimised parameters. The average micro-hardness of Ni60 and SiC–Ni60 coatings was 765.6 and 1072.4 HV, respectively. The corresponding wear resistance was also measured, and the composite coating showed a much lower friction coefficient and wear rate. The corrosion resistance of the coatings was evidently improved by the addition of SiC nanoparticles.
Helmet Mounted Sights (HMSs) become the important facilities to the cockpits of modern fighter aircraft. The HMSs based on the electromagnetic (EM) positioning have obviously advantages in no Line of Sight (LOS) occlusion, no Infrared Ray (IR) or thermal limitation, and no measure drifting. However, the application of EM HMSs is severely restricted by an inherent hemisphere ambiguity. A method to solve the inherent hemisphere ambiguity of electromagnetic positioning with single 3-axis magnetic source and single 3-axis magnetic sensor is proposed in this paper. The ambiguity is discriminated effectively to enlarge the positioning range of electromagnetic HMSs based on minimum Euclidean distance. Compared with traditional methods, it has significant advantages in positioning accuracy, real-time tracking and handling large-angle errors.