Ryo Ishibashi

Dr. Ryo Ishibashi

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 June 2022 in Coatings
Verified
Journal Article
Open access
PDF file
RIRyo Ishibashi
Ryo Ishibashi
YHYasunori Hayashi
Yasunori Hayashi
HBHuang Bo
Huang Bo
TKTakao Kondo
Takao Kondo
THTatsuya Hinoki
Tatsuya Hinoki
Replacement of conventional Zircaloy fuel cladding with silicon carbide (SiC) fuel cladding is expected to significantly decrease the amount of hydrogen generated from fuel claddings by the reaction with steam during severe accidents. One of their critical issues addressed regarding practical application has been hydrothermal corrosion. Thus, the corrosion resistant coating technology using a Ti-Cr multilayer was developed to suppress silica dissolution from SiC fuel cladding into reactor coolant under normal operation. The effect of radiation on adhesion of the coating to SiC substrate and its microstructure characteristics were investigated following Si ion irradiation at 573 K up to 3 dpa for SiC. Measurement of swelling in pure Ti, pure Cr and SiC revealed that the maximum inner stress attributed to the swelling difference was generated between the coating and SiC substrate by irradiation of 1 dpa. No delamination and cracking were observed in cross-sectional specimens of the coated SiC irradiated up to 3 dpa. According to analyses using transmission electron microscopy, large void formation and cascade mixing due to irradiation were not observed in the coating. The swelling in the coating at 573 K was presumed to be caused by another mechanism during radiation such as point defects rather than void formation.

1 January 2016 in Mechanical Engineering Journal
Verified
Journal Article
Open access
PDF file
RIRyo Ishibashi
Ryo Ishibashi
HHHisamitsu Hato
Hisamitsu Hato
FYFujio Yoshikubo
Fujio Yoshikubo
KMKatsumasa Miyazaki
Katsumasa Miyazaki
Our goal for this study was to understand the cause of the differences in surface properties between surfaces processed using water jet peening (WJP) and shot peening (SP) and to examine the compressive residual stress introduction process with low plastic strain using SP. The dynamic behaviors of stress and strain in surfaces during these processes were analyzed through elasto-plastic calculations using a finite-element method program, and the calculated results were compared with measured results obtained through experiments. Media impacting a surface results in a difference in the hardness and microstructure of the processed surface. During SP, a shot deforms the surface locally with stress concentration in the early stages of the impact, while shock waves deform the surface evenly throughout the wave passage across the surface during WJP. A shot with a larger diameter creates a larger impact area on the surface during shot impact. Thus, SP with a large-diameter shot suppresses the stress concentration under the same kinetic energy condition. As the shot diameter increases, the equivalent plastic strain decreases. On the other hand, the shot is subject to size restriction since the calculated results indicate the compressive residual stress at the surface decreased and occasionally became almost zero as the shot diameter increased. Thus, compressive residual stress introduction with low plastic strain by using SP is considered achievable by using shots with a large diameter and choosing the appropriate peening conditions.