In this paper, a high sensitive fiber-optic Fabry-Perot interferometer sensor based on gold diaphragm for acoustic detection has been proposed and experimentally demonstrated. The extrinsic Fabry-Perot interferometer (EFPI) comprises a 140-nm-thick gold diaphragm and the end-face of a fiber-optic collimator, both of which are enclosed into a structure made of glass tubes. A fiber-optic collimator is first adopted in acoustic sensing to reduce the light loss and improve the sensitivity. The experimental results show that the proposed sensor has a wide flat response range from 400 Hz to 12 kHz, almost covering the primary frequency component of audible sound. The pressure sensitivity and the minimum detectable acoustic pressure level (MDP) are measured to be −175.7 dB re 1rad/ $\mu $ Pa@150Hz and $95.3~\mu $ Pa/Hz 1/2 @2kHz, respectively. The proposed sensor has advantages of high sensitivity, wide flat response, low cost, and simple fabrication, which shows its potential as a fiber optical microphone with high sensitivity and high acoustic quality in practical applications.
In this paper, a sensing interrogation system for fiber-optic interferometer type of sensors by using a single-passband radio-frequency (RF) filter has been proposed and experimentally demonstrated. The fiber-optic interferometer based sensors can give continuous optical sampling, and along with dispersive medium a single-passband RF frequency response can be achieved. The sensing parameter variation on the fiber-optic interferometer type of sensors will affect their free spectrum range, and thus the peak frequency of the RF filter. By tracking the central frequency of the passband the sensing parameter can be demodulated. As a demonstration, in our experiment a fiber Mach-Zehnder interferometer (FMZI) based temperature sensor has been interrogated. By tracking the peak frequency of the passband the temperature variation can be monitored. In our experiment, the sensing responsivity of 10.5 MHz/°C, 20.0 MHz/°C and 41.2 MHz/°C, when the lengths of sensing fiber are 1 m, 2 m and 4 m have been achieved.
A surface plasmon resonance sensor based on a dual-groove photonic crystal fiber (PCF) for refractive index (RI) sensing with ultra-wide measurement range and high sensitivity is designed and theoretically investigated. The upper and right grooves of the PCF as different sensing channels are coated with Au or Au-TiO2 compound film. The influence of the parameters on the sensing performance of the designed sensor are analyzed. Numerical results show that the maximum wavelength sensitivity (WS) of 6800 nm/RIU with a wavelength resolution of 1.47 × 10 -5 RIU and maximum amplitude sensitivity (AS) of 5440 RIU -1 for the x polarization in the ultra-wide measurement range from 1.25 to 1.43 have been achieved. For y polarization, the proposed sensor has a maximum WS of 13200 nm/RIU and AS of 3465 RIU -1 in the detection range from 1.39 to 1.43. The corresponding wavelength resolution is obtained about 7.58 × 10 -6 RIU. Moreover, the ultra-wide range and high sensitivity of the sensor can be flexibly adjusted by a polarization controller to meet different practical requirements. Therefore, the proposed sensor would be a suitable candidate for medical testing, bio-sensing and environmental monitoring.
Fiber-optic sensors, especially fiber Bragg grating (FBG) sensors are very attractive due to their numerous advantages over traditional sensors, such as light weight, high sensitivity, cost-effectiveness, immunity to electromagnetic interference, ease of multiplexing and so on. Therefore, fiber-optic sensors have been intensively studied during the last several decades. Nowadays, with the development of novel fiber technology, more and more newly invented fiber technologies bring better and superior performance to fiber-optic sensing networks. In this paper, the applications of some advanced photonic technologies including fiber lasers and microwave photonic technologies for fiber sensing applications are reviewed. FBG interrogations based on several kinds of fiber lasers, especially the novel Fourier domain mode locking fiber laser, have been introduced; for the application of microwave photonic technology, examples of microwave photonic filtering utilized as a FBG sensing interrogator and microwave signal generation acting as a transversal loading sensor have been given. Both theoretical analysis and experimental demonstrations have been carried out. The comparison of these advanced photonic technologies for the applications of fiber sensing is carried out and important issues related to the applications have been addressed and the suitable and potential application examples have also been discussed in this paper.
Electrical current monitoring plays an important role in power transmission system, electric instruments, etc. The stability of the monitoring system is highly demanded. In this paper, a new interrogation scheme for a fiber Bragg grating (FBG) current sensor based on a dual-loop optoelectronic oscillator (OEO) with high stability, high precision and simple structure is proposed and experimentally demonstrated. The wavelength shift of the FBG, which is bonded on a magnetostrictive alloy-strip, is converted into the frequency shift of the microwave signal through the OEO system utilizing the wavelength to frequency mapping mechanism. Different from previous single-loop OEO schemes, a length of ∼1 km single mode fiber is used to form the second loop in the OEO-cavity, which can enhance the mode-selection ability and reduce the total gain requirement of the system. In addition, a fiber-ring-laser (FRL) cavity is adopted by integrating the sensing FBG-head as the wavelength-selective component to improve the quality of the optical carrier signal. The measured side-mode suppression ratio (SMSR) is up to 62.59 dB and the free spectral range (FSR) is five times larger than the single-loop structure, resulting in highly-enhanced stability and so the precision. Most importantly, the frequency fluctuation is as low as 0.277 ppm, which is the minimum to the best of our knowledge. Compensating methods for the influence of the temperature and the hysteresis are also discussed. The proposed scheme provides a feasible solution to promoting the development of OEO-based interrogation technology and its commercial applications.
In this paper, a novel approach to implement switchable and tunable microwave frequency multiplication has been proposed and experimentally demonstrated. High order harmonics of microwave signal with external modulation technique can be selected by using a novel switchable dual-passband microwave photonic filter (MPF) based on a modified fiber Mach-Zehnder interferometer (FMZI) and a dispersive medium. By adjusting the polarization controllers in the modified FMZI, the passbands of the MPF can switch between lower frequency, higher frequency or dual-passband states, and by changing the length of the variable optical delay line (VODL) in the modified FMZI, the central frequencies of these passbands can also be tuned. Therefore, tunable and switchable microwave signal frequency multiplication can be achieved. The experimental results show that by modulating a driving signal with frequency of 2.5 GHz, a signal with frequency of 7.5 GHz, which is three times of the driving frequency, the other one with the frequency of 15 GHz, which is six times of the driving frequency can be generated and freely switchable between two frequencies and dual frequency states by simply adjusting the polarization controllers in the modified FMZI.