Recently, the sonocatalytic technology using various semiconductors combined with ultrasonic irradiation has been received much attention to solve the environmental problems. In this paper, nano-sized titanium dioxide (TiO(2)) powder as a sonocatalyst was irradiated by ultrasound and the generation of reactive oxygen species (ROS) during sonocatalytic reaction process has been estimated by the method of Oxidation-Extraction Photometry (OEP). That is, the 1,5-diphenylcarbohydrazide (DPCI) can be oxidized by ROS into diphenylcarbonzone (DPCO), which can be extracted by the mixed solution of benzene and carbon tetrachloride and show the great absorbance at 563 nm wavelength. The synergistic effect of TiO(2) and ultrasonic irradiation was estimated and some influencing factors, such as ultrasonic irradiation time and TiO(2) addition amount on the generation of ROS were reviewed. The results indicate that the quantities of generated ROS increase with the increase of ultrasonic irradiation time and TiO(2) addition amount. Moreover, the relationship between quantities of generated ROS and DPCI concentration was also studied. And then, several quenchers were used to determine the kind of the generated ROS. At last, the researches on the sonocatalytic degradation of organic dyes and the corresponding reaction kinetics have also been performed, which is found to follow the pseudo first-order kinetics approximately. This paper may offer some important subjects for broadening the applications of sonocatalytic technology.
Nano-sized ZnO powder was introduced to act as the sonocatalyst after the treatment of high-temperature activation, and the ultrasound of low power was used as an irradiation source to induce nano-sized ZnO powder performing sonocatalytic degradation of acid red B and rhodamine B. At the same time, the effects of operational parameters such as solution pH value, initial concentration of dyestuff and addition amount of nano-sized ZnO powder have been examined in this paper. We found that the degradation ratios of acid red B and rhodamine B in the presence of nano-sized ZnO powder were much higher than that with only ultrasonic irradiation. However, the degradation ratio of acid red B was about two times higher than that of rhodamine B for the initial concentration of 10.0mg/L, addition amount of 1.0 g/L nano-sized ZnO powder, solution acidity of pH 7.0 and 60 min irradiation experimental condition. The difference of the degradation ratios can be illustrated by the difference of chemical forms of acid red B and rhodamine B in aqueous solution and the surface properties of nano-sized ZnO particles. In addition, the researches on the kinetics of sonocatalytic reactions of acid red B and rhodamine B have also been performed and found to the follow pseudo first-order kinetics. All the experiments indicated that the sonocatalytic method in the presence of nano-sized ZnO powder was an advisable choice for the treatments of non- or low-transparent organic wastewaters in future.
Here, a novel sonocatalyst, composite TiO2/ZnO powder, was prepared through the combination of nano-sized TiO2 and ZnO powders. Because of the appropriate adsorbability to organic pollutants and special crystal interphase between TiO2 and ZnO particles, the composite TiO2/ZnO powder exhibits a high sonocatalytic activity under ultrasonic irradiation during the degradation of acid red B. Especially, the sonocatalytic activity of composite TiO2/ZnO powder with 4:1 molar proportion treated at 500 degrees C for 50 min showed obvious improvement compared with pure nano-sized TiO2 and ZnO powders. When the experimental conditions such as 10mg/L acid red B concentration, 1.0 g/L catalyst addition amount, pH=7.0, 20 degrees C system temperature, 100 min ultrasonic time and 50 mL total volume were adopted, the satisfactory degradation ratio and rate were obtained. All experiments indicate that the sonocatalytic method using composite TiO2/ZnO powder may be a more advisable choice for the treatments of non- or low-transparent organic wastewaters in future.
The degradation of methyl parathion (O,O-dimethyl-O-(4-nitrophenyl)-phosphorothioate) using anatase titanium dioxide (TiO(2)) powder as heterogeneous sonocatalysts is reported. The influences of reaction parameters such as the species of TiO(2) sonocatalysts, methyl parathion concentrations, TiO(2) adding amount, pH, ultrasonic intensity, ultrasonic frequency and temperature have been investigated and the optimal conditions for eliminating methyl parathion have been identified. The efficiencies of sonocatalytic degradation in both nanometer and ordinary anatase systems are compared and the results indicate that the sonocatalytic activity of nanometer anatase TiO(2) powder is better than that of ordinary anatase TiO(2) powder. The primary degradation and the total mineralization of methyl parathion have been monitored by high performance liquid chromatography (HPLC) and UV-vis spectra, respectively. Methyl parathion got destroyed to some extent in both nanometer and ordinary anatase systems under ultrasonic irradiation. The kinetics for the degradation process of methyl parathion follows the first-order reaction. The degradation ratio of methyl parathion surpassed 90% within 50min in the optimal experiment conditions.