Operating helicopters in a naval environment is challenging because it imposes a pilot workload significantly higher than that during land-based operations. The aerodynamic interaction between the aircraft and the ship wake is known to play an important role in increasing the pilot workload, hence reducing the aircraft capability as a result of maintaining safety. As a further step toward numerical prediction of ship/helicopter operational limitations, computational-fluid-dynamics simulations are conducted for the Canadian Patrol Frigate. The effect of the rotor is included in the simulation, first using an actuator-disc method together with steady calculations, then using rotor blades and the unsteady Reynolds-averaged Navier–Stokes equations. Results using the actuator-disc method demonstrate the importance of coupling effects on the wake and rotor inflow when the rotor is operating close to the ship and therefore the invalidity of superposition methods. The case of a Sea King helicopter main rotor hove...
This paper demonstrates the potential of a compressible Navier–Stokes CFD method for the analysis of horizontal axis wind turbines. The method was first validated against experimental data of the NREL/NASA-Ames Phase VI (Hand, et al., 2001, “Unsteady Aerodynamics Experiment Phase, VI: Wind Tunnel Test Configurations and Available Data Campaigns,” NREL, Technical Report No. TP-500-29955) wind-tunnel campaign at 7 m/s, 10 m/s, and 20 m/s freestreams for a nonyawed isolated rotor. Comparisons are shown for the surface pressure distributions at several stations along the blades as well as for the integrated thrust and torque values. In addition, a comparison between measurements and CFD results is shown for the local flow angle at several stations ahead of the wind turbine blades. For attached and moderately stalled flow conditions the thrust and torque predictions are fair, though improvements in the stalled flow regime are necessary to avoid overprediction of torque. Subsequently, the wind-tunnel wall effects on the blade aerodynamics, as well as the blade/tower interaction, were investigated. The selected case corresponded to 7 m/s up-wind wind turbine at 0 deg of yaw angle and a rotational speed of 72 rpm. The obtained results suggest that the present method can cope well with the flows encountered around wind turbines providing useful results for their aerodynamic performance and revealing flow details near and off the blades and tower.