An improved understanding of the underlying physicochemical properties of respiratory aerosol that influence viral infectivity may open new avenues to mitigate the transmission of respiratory diseases such as COVID-19. Previous studies have shown that an increase in the pH of respiratory aerosols following generation due to changes in the gas-particle partitioning of pH buffering bicarbonate ions and carbon dioxide is a significant factor in reducing SARS-CoV-2 infectivity. We show here that a significant increase in SARS-CoV-2 aerostability results from a moderate increase in the atmospheric carbon dioxide concentration (e.g. 800 ppm), an effect that is more marked than that observed for changes in relative humidity. We model the likelihood of COVID-19 transmission on the ambient concentration of CO2, concluding that even this moderate increase in CO2 concentration results in a significant increase in overall risk. These observations confirm the critical importance of ventilation and maintaining low CO2 concentrations in indoor environments for mitigating disease transmission. Moreover, the correlation of increased CO2 concentration with viral aerostability need to be better understood when considering the consequences of increases in ambient CO2 levels in our atmosphere.
Respiratory pathogens can be spread though the transmission of aerosolised expiratory secretions in the form of droplets or particulates. Understanding the fundamental aerosol parameters that govern how such pathogens survive whilst airborne is essential to understanding and developing methods of restricting their dissemination. Pathogen viability measurements made using Controlled Electrodynamic Levitation and Extraction of Bioaerosol onto Substrate (CELEBS) in tandem with a comparative kinetics electrodynamic balance (CKEDB) measurements allow for a direct comparison between viral viability and evaporation kinetics of the aerosol with a time resolution of seconds. Here, we report the airborne survival of mouse hepatitis virus (MHV) and determine a comparable loss of infectivity in the aerosol phase to our previous observations of severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Through the addition of clinically relevant concentrations of mucin to the bioaerosol, there is a transient mitigation of the loss of viral infectivity at 40% RH. Increased concentrations of mucin promoted heterogenous phase change during aerosol evaporation, characterised as the formation of inclusions within the host droplet. This research demonstrates the role of mucus in the aerosol phase and its influence on short-term airborne viral stability.
The airborne transmission of disease relies on the ability of microbes to survive aerosol transport and, subsequently, cause infection when interacting with a host. The length of time airborne microorganisms remain infectious in aerosol droplets is a function of numerous variables. We present measurements of mass and heat transfer from liquid aerosol droplets combined with airborne survival data for Escherichia coli MRE162, an ACDP category 1 microorganism used as a model system, under a wide range of environmental conditions, droplet compositions and microbiological conditions. In tandem, these companion measurements demonstrate the importance of understanding the complex relationship between aerosol microphysics and microbe survival. Specifically, our data consist of the correlation of a wide range of physicochemical properties (e.g., evaporation rates, equilibrium water content, droplet morphology, compositional changes in droplet solute and gas phase, etc.), with airborne viability decay to infer the impact of aerosol microphysics on airborne bacterial survival. Thus, a mechanistic approach to support prediction of the survival of microorganisms in the aerosol phase as a function of biological, microphysical, environmental, and experimental (aerosol-generation and sampling) processes is presented. Specific findings include the following: surfactants do not increase bacteria stability in aerosol, while both the bacteria growth phase and bacteria concentration may affect the rate at which bacteria decay in aerosol.