This paper developed a 3D physical model of the hydraulic end of a high-pressure liquid hydrogen reciprocating pump to research the dynamic characteristics of the pump valve system. Based on dynamic mesh technology, we analyzed the coupling characteristics of pump valve and plunger motion and spool force considering the leakage model, closure model of valve gap, and compressibility of liquid hydrogen. Further, we analyzed the effect of the spring stiffness and preload force on the laws of motion of the pump valve. Finally, a liquid hydrogen pressurization test was conducted to revise the simulation model and verify the accuracy of the simulation. The results of the simulation and test show that the simulation method in this paper can simulate the liquid hydrogen pressurization process more accurately and obtain the motion law of the suction and discharge valves. Both the suction and discharge valves have an opening hysteresis angle of about 40°, and there is a strong coupling relationship between the spool motion and the piston motion and forces. The greater the preload force of the suction valve, the more obvious the oscillation effect of the suction valve. As the preload of the discharge valve increases, the opening hysteresis angle of the discharge valve increases significantly and the closing hysteresis angle decreases. The results of the research can provide some useful reference for the design of pump valves of high-pressure liquid hydrogen reciprocating pumps.
The rapid development of space launch vehicle has put forward increasingly strict requirements for engine startup characteristics and thrust regulation capabilities. The flow regulator is a critical component in the operation of liquid rocket engines, particularly due to its role in precise thrust control and self-adaptation to perturbations. This study focuses on the complex fluid–structure interaction phenomena present in liquid rocket engine flow regulators. A three-dimensional (3D) transient numerical model was constructed using computational fluid dynamics and dynamic grid methods to investigate the response mechanism of the regulator under various disturbances. After experimental verification, the model error is less than 3%. The results demonstrate that under sinusoidal pressure perturbations (10–50 Hz), the flow oscillation frequency and amplitude are directly proportional to the perturbation frequency. The amplitude of step pressure perturbations is approximately linearly related to the amount of mass flow rate overshoot. There existed an inverse relationship between vortex size and intensity and the magnitude of inlet perturbations. The characteristics of the flow field are closely coupled with the mass flow rate, and post-perturbation recovery depends on the restoration of the flow field. Furthermore, the existence of friction will cause the sliding sleeve to experience a stagnation phase, and the greater the friction, the longer the stagnation phase. These findings provide valuable insight into the intricate dynamics of liquid rocket engine flow regulators and contribute to the design and optimization of future liquid rocket engines.