Electromagnetic impact on oil reservoir manifests itself in various physical and chemical phenomena and attracts a significant scientific and technological interest. Microwave (MW) radiation heating can be more efficient for the oil recovery than heat transfer by convection or by thermal conduction. MW influence can also lead to significant changes in the physicochemical and rheological properties of oil caused by chemical processes of transformation of the oil high-molecular components such as resins and asphaltenes. The efficiency of transition-metal catalysts applied for the in-situ conversion of hydrocarbons directly in the reservoir might be significantly increased by exposing the oil formation to MW radiation. Actually, transition metals nanoparticles and their oxides are considered as active absorbers of MW radiation and; therefore, they can be used to intensify MW impact on the reservoir. Catalyst particles dispersed in the formation provide enhanced MW sweep. Taken together, the functioning of the catalysts and the effect of microwave radiation provide deep conversion of resins and asphaltenes, a decrease in the viscosity of the produced oil and an increase in oil recovery factor, along with a decrease in water cut of the well production. The present review analyzes the latest works on the combined application of microwave exposure and dispersed catalysts. In addition, this review discusses the prospects and perspectives of practical application of electromagnetic heating to enhance heavy oil recovery in the presence of nanoparticles.

The present paper reports experiments on microwave heating of a carbonate oil-containing rock sample in the presence and absence of an iron-magnetite-based nanocatalyst. It has been shown that the used catalyst improves the processes of destructive hydrogenation of resins and asphaltenes compounds in the oil. The chemical reactions analysis demonstrated a decrease in asphaltenes content and in their molecular weight, which increases the filtration capacity of the oil fluid in the reservoir rock porous medium. Moreover, the content of non-extractable organic matter in the rock sample after experiments and after oil extraction was determined. It has been found that the absence of the catalyst causes the least increase in the content of non-extractable organic matter in the rock. This fact is related to the intensive processes of resinous-asphaltene compounds destruction especially at the level of peripheral groups which are the most condensed fraction, and hence leads to a decrease in their solubility in the organic medium and eases their adsorption on the mineral skeleton surface.

Our knowledge of electromagnetic heating’s effect on heavy oil upgrading is largely based on very limited data. The aim of the present research was thus to study in detail the effect of microwave exposure in the absence and presence of nanosized magnetite on the composition of heavy oil. The obtained data reveal that the use of nanosized magnetite improves not only microwave radiation application as a result of its absorption and release of thermal energy but also that these nanoparticles have a catalytic ability to break carbon–heteroatom bonds in the composition of resins and asphaltene molecules. In fact, the overall reduction in asphaltenes or resins does not always adequately describe very important changes in asphaltene composition. Even a small fraction of broken carbon–heteroatom bonds can lead to an increase in the mobility of asphaltenes. Moreover, this study has shed light on the important evidence for asphaltenes’ transformation, which was found to be the formation of light aromatic compounds, such as alkylbenzenes, naphthalenes and phenanthrenes. These compounds were fixed in the composition of the aromatic fraction. We believe that these compounds could be the fragments obtained from asphaltenes’ degradation. The evidence from this study points toward the idea that asphaltenes’ destruction is crucial for increasing oil mobility in the reservoir rock during its thermal stimulation.

In-situ conversion of carbon dioxide into value-added products is an essential process in terms of heavy oil upgrading and utilization of the main anthropogenic greenhouse gas. In this paper, we discuss a synthesis of sodium-coated magnetite (Fe₃O₄) particles for in-reservoir hydrogenation of CO₂. The performance of the obtained catalyst was tested in upgrading of heavy oil in a High Pressure/High Temperature (HPHT) reactor imitating the reservoir conditions during steam injection techniques. The experiments were conducted for 48 h in a CO₂ environment under the steam temperature and pressure of 250 °C and 90 bar, respectively. The results showed irreversible viscosity reduction of oil from 3931 mPa^.s to 2432 mPa^.s after the degassing of unreacted carbon dioxide. The content of resins in the composition of upgraded oil was significantly altered from 32.1 wt% to 19.01 wt%, while the content of aromatics rose from 32.5 wt% to 48.85 wt%. The GC-MS results show the presence of alkyl benzenes and phenanthrenes, which were initially concentrated in resins and asphaltenes, in the aromatics fraction of upgraded crude oil. Thus, Na-Fe₃O₄ exhibits promising results for in-situ heavy oil upgrading through the hydrogenation of carbon dioxide, which contributes not only to the reduction of greenhouse gas emissions, but also enhances heavy oil recovery.