The objective of this study was the definition and determination of sustainable water consumption indicators for activity categories, as well as the evolution of water consumption in commercial buildings. These indicators were determined through statistical analyses using Shewhart charts. Within a broader scope, the research proposed a methodology to automate sustainable management of water consumption in building operation using BIM–IoT–FM integration. The scientific rigor of the methodology was based on the precepts of design science research. The methods proposed for the construction of functionalities and the application of the reference indicators provided an optimized analysis of water consumption and the detection of excess consumption and leaks. The methodology, implemented in an online prototype, AquaBIM, could deliver a significant advance for building management. A conceptual test of AquaBIM evaluated the consumption indicators and validated our methodology through its application in a commercial building. The building consumption analyses showed a potential for approximately 15% savings. In addition, five requirements of the international sustainability certification AQUAHQE were met. The results of our research provide an innovative approach for the automation of sustainable building management and could be expanded to monitor and report on the consumption of other critical resources such as electricity and gas.
Multivariate Statistical Process Control (MSPC) techniques require process stationarity as a main rule for design and monitoring. However, a critical process such as Boiler and Turbine-Generator units of Thermoelectric Power Plants, which is a multivariable complex system, features different types of non-stationary behavior and operational modes with constant changes of set points of key performance variables. A methodology based on MSPC and Principal Component Analysis (PCA) is presented with an adaptive mean estimator that deals with frequent changes of set points, both for design and just in time monitoring. Experimental results, based on data from a power plant, illustrate the application and use of the methodology.
This paper presents a comparative analysis among four control strategies for the control of a combined anaerobic-aerobic wastewater treatment configuration. The anaerobic stage is an Upflow Anaerobic Sludge Blanket (UASB) reactor, whereas the aerobic stage consists of the Activated Sludge (AS) process. The control variables are solids concentration in the effluent and sludge wastage rate. The proposed control strategy is considered the most reliable among them. It is based on two cascaded PI-controllers for the solids concentration in the effluent and a look-up table for the sludge wastage rate control. Experimental and simulated results are presented.
26 February 2018 in International Journal of Systems Science
A multiple model recursive least squares algorithm combined with a first-order low-pass filter transformation method, named λ-transform, is proposed for the simultaneous identification of multiple model orders continuous transfer functions from non-uniformly sampled input–output data. The λ-transformation is shown to be equivalent to a canonical transformation between discrete z-domain and δ-domain using the negative value of the λ-transform filter time-constant instead of the sampling interval parameter. The proposed algorithm deals with oversampling, sampling jitter or non-uniform sample intervals without the need for extra digital anti-aliasing pre-filtering, downsampling or interpolation algorithms, producing multiple models with a cost function that facilitates automatic selection of best-fitted models. Besides, measurement noise is noted as beneficial, bringing up an inherent bias toward low-order models. Simulated examples and a drum-boiler level experimental result exhibiting non-minimum phase behaviour illustrate the application of the proposed method.