In the air drilling process, the pre-bent pendulum bottom hole assembly (PBP-BHA) has excellent performance in controlling the well deviation and improving the wellbore quality, but the mechanism that is closely related to the dynamics of the PBP-BHA has not been ascertained. In this paper, an effective technique combining the weighted residuals method with the finite element method is presented to study the PBP-BHA lateral vibration. First, a three-dimensional nonlinear static model of pre-bent BHA is established under small deformation condition and solved by the weighted residuals method and optimization method, so as to define the tangent point according to the deformation characteristics of the PBP-BHA. This tangent point determines the end of the effective PBP-BHA length that starts from the drill bit. Subsequently, the finite element model of PBP-BHA is established to solve the lateral natural frequencies and mode shapes of the PBP-BHA. After considering the borehole wall constraint, the modal superposition technique is used to obtain the steady dynamic responses of the PBP-BHA. Meanwhile, the dynamic performance of the PBP-BHA used in the actual air drilling process is calculated to obtain its critical speeds and working status chart. The critical speeds of the PBP-BHA are 80 r/min and 190 r/min, which are far away from the surface rotary speed in the actual drilling site. Through comparing with the dynamic characteristics of regular BHA with the same structural parameters, it is discovered that the bend angle in the PBP-BHA plays a crucial role in improving the dynamic performance of the PBP-BHA. Moreover, the technique presented in this study can be used to make a reasonable design of BHA configuration and optimize drilling parameters.
Stick–slip vibration is a common phenomenon in ultra-deep drilling that significantly impacts the failure of both drill bits and drill tools. The most direct and efficacious approach to alleviating the stick–slip vibration of the drill string in the downhole is to modify its external excitation. In recent years, the composite impact tools that can simultaneously offer axial and torsional excitation in the downhole have been applied, effectively reducing the stick–slip vibration of the drill string. However, the mechanical mechanism thereof remains undefined. In order to understand the nature of this phenomenon, A dynamic model of the drill string taking into account multi-directional excitations is presented. The governing nonlinear equations are obtained by using the Lagrangian approach, which take the work done by the multidirectional excitation into consider. The Hertz contact model is introduced considering the constraints of the wellbore, and the finite element node iteration method is employed to solve the dynamics equation of drill string. The axial vibration, torsion vibration and phase trajectory characteristics of the drill string under multidirectional excitation are analyzed, and the inhibitory effect of the excitations on stick–slip vibration is clarified. The results show that the vibration characteristics of the bottom hole assembly can be significantly altered through periodic axial and torsional excitations at higher frequencies, resulting in the emergence of high-frequency vibration responses. These responses exhibit a pronounced inhibitory effect on stick–slip suppressed.
16 November 2025 in Geoenergy Science and Engineering
Great difficulties have been encountered in the study of the seal failure of casing connection. The in situ microscopic seal surfaces under complex loads are hard to be obtained due to the engagement characteristics of thread. In this study, a method to construct the microscopic seal surfaces of a specified 7 casing PTC under complex loads was proposed. Then, the lattice Boltzmann method (LBM) was applied to simulate the fluid flow inside the microchannel between the seal surfaces. The effect of pressure gradient and wettability on the flow behavior of a multicomponent fluid system at the microscopic scale was analyzed. Pressure gradient has a huge influence on the volume fraction of sealing compound and the average velocity of displacing fluid. The volume fraction of sealing compound decreases with the increase of pressure gradient. Break-through can be observed for fluid systems with relatively larger pressure gradient. For the systems with , , and , the break-through time steps are around 61000, 99000, and 295000, respectively. Wettability has huge impact on the distribution of sealing compound, and break-through was not observed for the fixed pressure difference with various wettability. It is expected to provide some new insights for understanding the seal failure of casing connections at the microscopic level.