Direct pyrolysis of citric acid (CA) has been proved to be a facile bottom–up technique for making pristine carbon dots (CD) with homogenous size distribution. However, limited reports are available on systematic optimization of carbonization degree. In this investigation, pyrolysis temperatures between 160 °C and 220 °C were studied, based on CA thermal decomposition path, using various heating durations. The effect of the formation of more carbonized carbon particles (MCCPs), as the major byproduct of this method, on photoluminescence properties of CDs was also considered. The NaOH amount that neutralizes the solution and the effect of dilution on the emission intensity, were introduced as simple and accessible factors for monitoring carbonization degree, and an estimate of MCCP/CD ratio, respectively. The results show that the CDs fabricated at 160 °C, 50 minutes attain almost twice higher quantum yield (QY) of 29% than highest QY reported based on pyrolysis of CA. The so–prepared CDs can be employed as excellent candidates for turn–off sensing. As a proof of concept, detection limit of 50 nM for Hg2+ was achieved using a facile and inexpensive smartphone set–up that is able to quantify and compare fluorescent intensity in several samples simultaneously.
1 September 2012 in Computational Materials Science
In this study, a proper and reliable fluorometric method is introduced for screening acetylcholinesterase (AChE) and its inhibitors, using carbon quantum dots (CQDs) as the signal reporter. Pure, S-doped, and P-doped CQDs, were synthesized and their recoverable fluorescence quenching properties were observed, when exposed to Hg2+, Cu2+, and Fe3+ quenching ions, respectively. The study on the recovery of their emission showed that after the introduction of another guest substance with a stronger affinity to the quenching ions, their fluorescence is restored. The Design Expert software was employed to compare the performance of the three CQDs, as fluorescent probes, based on their quenching efficiency and the percentage of their emission recovery in the presence of AChE and acetylthiocholine (ATCh). Based on the statistical analysis, among the studied CQDs, S-doped CQD was the most suitable candidate for sensor designing. The detection mechanism for the proposed S-doped CQD-based sensor is as follows: The strong binding of Cu2+ ions to carboxyl groups of S-doped CQD quenches the fluorescence signal. Then, hydrolysis of ATCh into thiocholine (TCh) in the presence of AChE causes fluorescence recovery, due to the stronger affinity of Cu2+ to the TCh, rather than the CQD. Finally, in the presence of malathion and chlorpyrifos inhibitors, AChE loses its ability to hydrolyze ATCh to TCh, so the fluorescence emission remains quenched. Based on the proposed detection technique, the designed sensor showed detection limits of 1.70 ppb and 1.50 ppb for malathion and chlorpyrifos, respectively.
In This study, finite element models of Single-Walled Carbon Nanotube (SWCNT) in their perfect form were generated. Then, after deriving mechanical properties in agreement with existing literature values, different levels of perturbation and missing atoms in the structure were applied. In another approach, some of the Carbon atoms were replaced with Silicon to produce a Si-doped SWCNT. Mechanical properties of the three kinds of imperfect structures of SWCNT were then compared with the perfect structure results, for both fundamental Carbon Nanotubes, namely Zigzag and Armchair.The results show that with any kind of imperfection, the stiffness of the structure decreases compared to the perfect SWCNT.
20 July 2007 in Journal of Physics D: Applied Physics