Cigarette smoke is harmful to human health at both cellular and genetic levels. Recently, a unique bioassay for smoke cytotoxicity using air pollution-sensitive plant cells (tobacco) has been proposed.
1 September 2015 in Journal of Bioscience and Bioengineering
The influenza virus has been known as a representative infectious virus that harms human health from the past to the present day. We have promoted the development of a novel adsorbent capable of adsorbing influenza viruses in the form of aerosols in the air. In this study, to develop a material to adsorb the influenza virus, a functional group was introduced into a microfiber nonwoven fabric (MNWF) manufactured through radiation-induced graft polymerization (RIGP), and sialic acid was immobilized to mimic the sugar chain cluster effect. The functional group was used by coupling disodium iminodiacetate monohydrate (IDA) and 1-(3-dimethylaminopropyl)-3-ethylcarbodiimide hydrochloride (EDC), and N-acetylneuraminic acid (NANA) was selected for sialic acid. IDA-EDC was introduced into GMA MNWF with an average molar conversion of 47%. For NANA MNWF with a degree of grafting (dg) of 87% introduced with sialic acid, 118.2 of 200 µg of aerosolized lectin was adsorbed, confirming that the maximum adsorption amount was 59.1%. In NANA MNWF of 100% or more dg, a tendency to decrease the amount of lectin adsorption was observed compared to NANA MNWF of 80–100% dg.
The detection and removal of volatile organic compounds (VOCs) are emerging as an important problem in modern society. In this study, we attempted to develop a new material capable of detecting or adsorbing VOCs by introducing a new functional group and immobilizing metal ions into a microfiber nonwoven fabric (MNWF) made through radiation-induced graft polymerization. The suitable metal complex was selected according to the data in “Cambridge Crystallographic Data Center (CCDC)”. 4-picolylamine (4-AMP), designated as a ligand through the metal complex data of CCDC, was introduced at an average mole conversion rate of 63%, and copper ions were immobilized at 0.51 mmol/g to the maximum. It was confirmed that degree of grafting (dg) 170% 4-AMP-Cu MNWF, where copper ions are immobilized, can adsorb up to 50% of acetone gas at about 50 ppm, 0.04 mmol/g- 4-AMP-Cu-MNWF, at room temperature and at a ratio of copper ion to adsorbed acetone of 1:10.
Peat fires cause large amounts of greenhouse gas emissions, posing significant environmental challenges related to smoke pollution, health hazards, and ecological impacts. Water alone is inefficient for extinguishing peat fires as it struggles to penetrate the soil. Therefore, firefighting agents with high penetration capabilities are added to improve effectiveness. Experiments were conducted in Palangka Raya, Indonesia, to evaluate an environmentally friendly soap-based firefighting agent against peat fires. A 1.5 m × 1.5 m peat area was burned for 24 h to simulate a peat fire, and either groundwater or a 1 vol.% soap-based firefighting agent solution was used for firefighting. Under the former measure, the water required to extinguish the fire was 16.0 and 23.9 L/m2, while under the latter it was reduced to 3.8 and 7.4 L/m2 with the soap-based solution. The time to extinguish the fire was also reduced to approximately one-third under the application of the soap-based solution compared to that required when using water alone. The soap-based firefighting agent proved more effective against peat fires in Indonesia than water alone, reducing both the amount of spray and the time required for spraying. This agent is expected to assist in efficiently managing peat fires, which have become more severe in recent years.