Thin 2D Mo ₂ C/graphene vertical heterostructures have attracted significant attention due to their potential application as electrodes in the hydrogen evolution reaction (HER) and energy storage. A common drawback in the chemical vapor deposition synthesis of these structures is the demand for high temperature growth, which should be higher than the melting temperature of the metal catalyst. The most common metallic catalyst is Cu, which has a melting temperature of 1084 °C. Here, we report the growth of thin, ∼200 nm in thickness, semitransparent micrometer-sized Mo ₂ C domains and Mo ₂ C/graphene heterostructures at lower temperatures using liquid Sn–Cu alloys. No Sn-associated defects are observed, making the alloy an appealing growth substrate. Raman spectroscopy reveals the vertical interaction between graphene and Mo ₂ C, as shown by the variation in the strain of the graphene film. The results demonstrate the capability to grow continuous nanometer-thin Mo ₂ C films at temperatures as low as 880 °C, without sacrificing the growth rate. Mo ₂ C films are proven to be efficient electrocatalysts for the HER. Moreover, we demonstrate the beneficial role of graphene overgrown on Mo ₂ C in reducing the HER overpotential values, which is attributed to more efficient charge transfer kinetics, compared to pure Mo ₂ C films.

Self-organized porous TiO(2) nanotubes (NTs) were prepared on conductive glass by galvanostatic anodizing of sputtered titanium in an NH(4)F /glycerol electrolyte. DC magnetron sputtering at an elevated substrate temperature (500 degrees C) was used to deposit 650 nm thick titanium films. After anodizing, NTs, 830 nm long, with an average external diameter of 92 nm, were grown; this gave a high conversion rate of oxide from titanium (1.9), with a 220 nm thick layer of titanium, which was not oxidized, located at the base of the tubes. The NTs revealed a mainly amorphous structure, which transformed mostly to anatase upon thermal treatment in air at 450 degrees C. The tubes were sensitized by the N719 complex and the resultant photoelectrodes were incorporated into liquid dye solar cells (DSCs) and further tested under back-side illumination. High values of V(oc) (714 mV) were obtained under 1 sun (AM 1.5), assigned to low dark current magnitude and large recombination resistance and electron lifetime. In addition, typical values of fill factors (of the order of 0.62) were attained, in agreement with the estimated ohmic resistance of the cells in combination with low electron transfer resistance at the platinum/electrolyte interface. The overall moderate power conversion efficiency (of the order of 0.3%) was mainly due to the low short-circuit photocurrents (J(sc) = 0.68 mA cm(-2)), which was confirmed further by the corresponding IPCE values (5.2% at 510 nm). The magnitude of J(sc) was attributed to absorbed light losses due to back-side illumination of the cells, the low dye loading (due to the limited thickness of anodic titania) and the high charge transfer resistance at the TiO(2)/conductive substrate due to the presence of barrier layer(s) underneath the tubes. These preliminary results encourage the DSC community to explore further the galvanostatic anodizing of titanium in order to produce highly efficient porous TiO(2) NTs directly on conductive glass. Current work is focusing on achieving complete anodizing of the metal substrate and full transparency for the photoelectrode in order to increase and optimize the resultant cell efficiencies.