Graphitic carbon nitride (g-C3N4)-based materials exhibit an organized layered porous structure and a band position optimum for the development of various optoelectronic devices and photocatalysts.
Well-defined Zn2GeO4/g-C3N4 nanocomposites with a band alignment of type-I were prepared by the ultrasound-assisted solvent method, starting from g-C3N4 nanosheets and incorporating 0, 10, 20, and 40 wt% of Zn2GeO4. In this study, we have investigated in-depth the photoluminescence emission and photocatalytic activity of these nanocomposites. Our experimental results showed that an increased mass ratio of Zn2GeO4 to g-C3N4 can significantly improve their photoluminescence and photocatalytic responses. Additionally, we have noted that the broadband photoluminescence (PL) emission for these nanocomposites reveals three electronic transitions; the first two well-defined transitions (at ca. 450 nm and 488 nm) can be attributed to π*→ lone pair (LP) and π*→π transitions of g-C3N4, while the single shoulder at ca. 532 nm is due to the oxygen vacancy (Vo) as well as the hybridization of 4s and 4p orbital states in the Zn and Ge belonging to Zn2GeO4. These experimental findings are also supported by theoretical calculations performed under periodic conditions based on the density functional theory (DFT) fragment. The theoretical findings for these nanocomposites suggest a possible strain-induced increase in the Zn-O bond length, as well as a shortening of the Ge-O bond of both tetrahedral [ZnO4] and [GeO4] clusters, respectively. Thus, this disordered structure promotes local polarization and a charge gradient in the Zn2GeO4/g-C3N4 interface that enable an efficient separation and transfer of the photoexcited charges. Finally, theoretical results show a good correlation with our experimental data.
Nanometric thin films have always been chiefly used for decoration; however they are now being widely used as the basis of high technology. Among the various physical qualities that characterize them, the thickness strongly influences their properties. Thus, a new procedure is hereby proposed and developed for determining the thickness of V2O5nanometric thin films deposited on the glass surface using Portable X-Ray Fluorescence (PXRF) equipment and the attenuation of the radiation intensity Kαof calcium present in the glass. It is shown through the present paper that the radiation intensity of calcium Kαrays is proportional to film thickness in nanometric films of vanadium deposited on the glass surface.
The V2O5 thin films has been widely studied because it has application as ionic host in electrochromic and lithium-ion batteries, two technologies that have an intimate connection with sustainability as substitutes for fossil energies and as agents for improving energy efficiency. In electrochromic technology, V2O5 is applied as a passive electrode due to its high transmittance and small contrast, and its reversibility on electrochemical reactions. To contribute to increase the optical and charge efficiency of V2O5 thin film passive electrodes, were investigated in this work the influence of the morphological properties, crystallite size and roughness, on the reversible specific charge capacity and the respective optical responses. The films morphological properties were modified by varying their thickness to the nanoscale. The films were deposited by thermal evaporation from powdered V2O5. The crystallite size and surface roughness were measured respectively by XRD and AFM. The results showed that the charge capacity is directly proportional to the surface roughness and inversely proportional to the crystallite size. The film optical contrast and the nominal transmittance shows to be improved according to their morphological properties. In conclusion, the V2O5 opto-electrochemical properties can be improved, increasing the efficiency on the light control processes.