Due to local resonances, high vibration levels occur frequently in high-speed train floor, which impact on the ride comfort negatively. A method to control excessive local vibration with multiple dynamic vibration absorbers (DVAs) is presented. Firstly, possible causes of the high vibration levels are investigated with operational and modal tests. Then a model of the vehicle body with multiple DVAs is established based on the modal superposition method. It is found that a strong peak at the low frequency is dominated by a single mode, which can be attenuated with under-frame equipment as a single DVA. In the frequency region between 30 and 35 Hz several local modes contribute, and are controlled with multiple DVAs. Methods are studied to determine the optimal parameters for these DVAs, including location, natural frequency and mass. For a single DVA conventional fixed-point theory is used, whereas for multiple absorbers an optimization method is proposed. Finally, the effect of the optimization is verified in a full vehicle model with frequency responses analysis. The results indicate that the proposed method can reduce the vibration of targeted modes and improve the ride quality considerably in terms of the vertical motion.

An on-site test has been performed to address the problem of feet numbness caused by the floor vibration of high-speed railway vehicles. Analysis of the floor vibration performance indicates that the vibration of the car body chassis transmitted to the floor by the elastic supports is significantly amplified in the frequency range of 20–50 Hz. This overlaps with the frequency range in which human lower extremities are most sensitive, leading to feet numbness. A refined finite element model of the car body, including the floor panels is developed to further study the vibration mechanism of the floor. Results show that due to the inappropriate design of the elastic support stiffness, the deformations of the floor above the bogie centre for several typical modes in the frequency range of 20–50 Hz are significantly amplified. When the excitation frequencies transmitted from the car body chassis were close to the eigenfrequencies of the floor, the local resonance of the floor will occur, which is the root cause of human feet numbness. The dynamic stiffness of the elastic support is further optimised, and the experimental verification shows that the vibration transmissibility from the car body chassis to the floor in the frequency range of 20–50 Hz has been significantly reduced, and the problem of feet numbness has been solved.