Enzyme-free amplification techniques based on dynamic DNA self-assembly (DDSA) have recently been developed for the in situ detection of mRNA in living cells. However, signal generation in traditional DDSA amplifiers is mainly dependent on the random diffusion of dissociative probes in a bulk solution, which is generally accompanied by poor kinetics and interference from complex biological systems. In this work, a new amplifier based on the design of an intramolecular catalytic hairpin assembly (intra-CHA) is proposed for the FRET imaging of mRNA in living cells. Compared with that in the free catalytic hairpin assembly (free-CHA), probes H1 and H2 in intra-CHA were simultaneously fixed on a DNA tetrahedron. The distance between them was closer, the local concentration of H1 and H2 in intra-CHA was theoretically approximately 808-times higher than that in free-CHA, and the initial reaction rate was enhanced 15.6 fold. Due to the spatial confinement effect, the reaction kinetics for target-catalyzed signal generation were significantly improved. By virtue of the three-dimensional nanostructure, H1 and H2 in the intra-CHA amplifier entered cells without any transfection or nanocarrier, and the probes and their products were free from biological interference, providing much higher signal stability for the reliable imaging of mRNA in living cells.
Tetracycline (TC) is widely used to treat bacterial infections in humans and animals due to its low price and good antibacterial properties. The abuse of tetracycline has led to TC residues in daily food that could seriously affect human health. Thus, it is imperative to develop highly sensitive and selective methods for TC detection. In this work, we developed a colorimetric method for TC detection based on an enzyme-linked aptamer assay (ELAA) with multivalent HRP-mimicking DNAzyme. An aptamer was used as an alternative recognition element in the enzyme-linked immunosorbent assay (ELISA). Multivalent HRP-mimicking DNAzyme, assembled via hybridization chain reactions (HCR), was used for catalytic substrate color rendering in ELAA. The multivalent HRP-mimicking DNAzyme exhibited enhanced catalytic capacity and improved the detection sensitivity greatly. The limit of detection was 8.1 × 10−2 ng mL−1 with a linear range from 1.0 × 10−2 ng mL−1 to 1.0 × 104 ng mL−1 toward TC in buffer. To challenge the practical application capability of this strategy, the detection of TC in milk samples was also investigated and showed similar linear relationships. Due to the introduction of an aptamer, this ELAA strategy shows high selectivity towards TC and has potential for the detection of a wide spectrum of analytes.