In this paper, the authors report the first demonstration of an InAs/Al 0.45 Ga 0.55 Sb heterojunction TFETs fabricated using an optical-lithography-only, self-aligned process and also investigate the effects limiting the InAs/Al 0.45 Ga 0.55 Sb TFET performance.
Conduction and valence band states for the highly mismatched alloy (HMA) Ge:C are projected onto Ge crystal states, Ge vacancy states, and Ge/C atomic orbitals, revealing that substitutional carbon not only creates a direct bandgap but also the new conduction band is optically active. Overlap integrals of the new Ge:C conduction band state with states from unperturbed Ge show that the new band cannot be attributed to any single Ge band but is a mixture of multiple Ge states. The Ge Γ conduction band valley state plays the largest single role, but L and X valley states collectively contribute a larger share than Γ due to the multiplicity of degenerate states. C sites structurally resemble uncharged vacancies in the Ge lattice, similar to Hjalmarson's model for other HMAs. C also perturbs the entire Ge band structure even at the deepest crystal core energy levels, particularly if staggered supercells are used to mimic a disordered alloy. Projection onto atomic sites shows a relatively weak localization compared with other HMAs, but it does show a strong anisotropy in probability distribution. L-valley conduction band states in Ge contribute to the conduction band minimum in Ge:C, but the optical transition strength in Ge:C remains within a factor of 2 of the direct gap transition in Ge.
We studied the effects of ion damage on the optical properties of dilute nitrides grown by plasma-assisted molecular-beam epitaxy. A dual-grid retarding field ion energy analyzer was used to measure the ion flux and ion energy distribution at the substrate position from an Applied-EPI UniBuilb™ rf plasma cell. These changes were measured as the negative deflector plate voltage varied from 0 to . The largest ion flux resulted with a setting, while the greatest ion energies occurred with . Deflector plate voltages more negative than resulted in a significant reduction in both the ion flux and ion energy. The damage caused by these ions was determined by measuring the pre- and postanneal photoluminescence properties of quantum wells. Comparable optical properties were possible with various combinations of ion fluxes and ion energies, which demonstrate how the ion flux and ion energy each impart an individual effect on the sample’s optical properties. An awareness of these effects is crucial because the optical properties of dilute nitrides grown with an improper deflector plate voltage setting can lead to a greater degree of ion damage to the sample.
Tensile-strained pseudomorphic Ge1–x–ySnxCy was grown on GaAs substrates by molecular beam epitaxy using carbon tetrabromide (CBr4) at low temperatures (171–258 °C). High resolution x-ray diffraction reveals good crystallinity in all samples. Atomic force microscopy showed atomically smooth surfaces with a maximum roughness of 1.9 nm. The presence of the 530.5 cm−1 local vibrational mode of carbon in the Raman spectrum verifies substitutional C incorporation in Ge1–x–ySnxCy samples. X-ray photoelectron spectroscopy confirms carbon bonding with Sn and Ge without evidence of sp2 or sp3 carbon formation. The commonly observed Raman features corresponding to alternative carbon phases were not detected. Furthermore, no Sn droplets were visible in scanning electron microscopy, illustrating the synergy in C and Sn incorporation and the potential of Ge1–x–ySnxCy active regions for silicon-based lasers.
We present electronic band structure calculations of BxGa1−xAs alloys over the full composition range using HSE06 hybrid functionals. We find that at low boron percentages, the direct bandgap decreases slightly and then increases toward the large minimum direct gap of BAs as more boron is added. Our results show that the effect of isolated boron atoms on the bandgap is small (<5%) at concentrations below 13%. We estimate that BGaAs transitions from the direct to indirect bandgap at around 18% boron content. We calculate the electron effective masses in the direct bandgap region and investigate the effect of B-B pairs in nearest-neighbor group III sites on the bandgap, conduction band dispersion, and total free energy. We find that the lattice constant of BGaAs follows Vegard's law and estimate that the boron concentration required to lattice match BGaAs to silicon is outside the direct gap regime.
Contactless electroreflectance (CER) spectroscopy has been applied to study band bending in quantum well (QW) structures. It has been observed that CER features significantly changes upon annealing: the period of GaAs-related Franz-Keldysh oscillations increases; intensities of excited QW transitions rose compared to the intensity of the fundamental QW transition. The observed changes in CER spectra have been explained by a shift of the Fermi level in the GaInNAsSb layer: the defect states in as-grown GaInNAsSb tend to pin the Fermi level at an energy characteristic for these defects; annealing removes defects from this material and effectively shifts the Fermi level to the conduction band.