The present study focuses on the processing and properties of epoxy foams by the use of CO2 blocked hardener N-aminoethylpiperazine (B-AEP) and different resins. Although some studies described the foaming with carbamates, little attention has been given to the interaction of resin properties (such as viscosity) on the foaming performance. Therefore, two resins, diglycidyl ether of bisphenol-A (DGEBA) and epoxy novolac (EN), as well as their 50:50 blend, were foamed with B-AEP and unblocked/blocked AEP hardener mixtures in a batch foaming process. Furthermore, the commercially available chemical blowing agent para-toluenesulfonyl hydrazide (TSH) was used as a benchmark for commonly used chemical blowing agents. The lowest density in this study was reached by the DGEBA+B-AEP system in the range of 215 kg/m3 with the drawback of an inhomogeneous cell structure and high cell size distribution. The best cell morphology and lowest cell size distribution was reached with the EN+15:85% unblocked:blocked hardener mixture, resulting in a density in the range of 394 kg/m3. A syntactic foam was achieved by a DGEBA+50:50% unblocked:blocked hardener mixture with a density of around 496 kg/m3. It was found that a higher viscosity of the resin lead to an increase in the density and a decrease in the cell size distribution range as a result of a closer expansion time window.
28 June 2016 in Journal of Applied Polymer Science
The research proposed an aqueous emulsion foaming process to produce a viscoelastic epoxy foam having a density of 0.33–0.36 g/cm3 from the polyamide–epoxy adduct, which uses a reverse ratio of epoxy and polyamide hardener. The process is simple, economical and uses no surfactant, thanks to the emulsifying ability of polyamide hardener. Firstly, the mixture of excess polyamide, epoxy and sodium bicarbonate was emulsified with distilled water using high-speed stirring to form dispersed epoxy droplets in water. Secondly, a solution of ammonium chloride was added, which reacted with sodium bicarbonate to produce carbon dioxide and ammonia gases dispersed in the epoxy emulsion. The expanding gases induced flocculation and partial coalescence of the epoxy droplets; sequentially water molecules were entrapped within them. Finally, a curing process was carried out to stabilise the foam morphology and structure. Two types of pore morphologies were observed: a large foam-pore generated from blowing-agent gases and a cell-wall pore formed from the vapourisation of entrapped water (as the void template). Porosity and pore morphologies depended on blowing-agent content, and the viscoelasticity was affected by the epoxy/polyamide ratio. The obtained viscoelastic foams showed a large number of interconnected cells and exhibited high compression set values.