To achieve high gains from multiple antennas in 5G systems, the base station (gNB) constructs precoders using channel measurements obtained based on pilot signals. For high user mobility, the measurements quickly become outdated, which is especially crucial for ultra-reliable low latency communications (URLLC) traffic because it increases channel resource consumption to provide highly reliable transmissions and, consequently, reduces system capacity. Frequent pilot transmissions can provide accurate channel estimation and high-quality precoder but lead to huge overhead. Fortunately, 5G systems enable flexible time division duplex (TDD), which allows the gNB to dynamically change the configuration of downlink and uplink slots and tune the period of channel measurements. The paper exploits this feature and designs a new prediction approach based on autoregression and flexible TDD (PABAFT) that forecasts the channel between consequent pilots transmissions. To learn fine-grained channel properties, the gNB configures uplink pilot transmission in each slot. When the training data are collected, and the model is fitted, the gNB switches back to the regular slot configuration with a long pilot transmission period. Extensive simulations with NS-3 in high-mobility scenarios show that PABAFT provides the signal-to-noise ratio (SNR) close to that with the ideal knowledge of the channel at the gNB. In addition, PABAFT significantly reduces channel resource consumption and, thus, increases capacity for URLLC traffic in comparison to the existing solutions.
A deep investigation of Reconfigurable Intelligent Surfaces (RIS) and Holographic MIMO (H-MIMO) surfaces in 5G and beyond systems requires numerous tests with various prototypes. Traditional prototyping of these surfaces relies on expensive or time-consuming printed circuit board technologies. Alternatively, additive manufacturing, particularly 3D-printing, offers rapid prototyping of radio frequency components with sophisticated geometry and low cost. This paper presents a novel methodology for additive manufacturing of RIS elements (AMoRE). AMoRE provides a detailed description of the production process of 3D-printed elements of the surface, including dielectric material characterization and waveguide design for measurement. An experimental and simulation comparison of traditional and 3D-printed elements of the surface demonstrates that the latter increases the bandwidth by 40% and reduces losses, being five times cheaper and having the same thickness. The results highlight the potential of additive manufacturing to enable rapid and cost-effective prototyping of the surfaces compared with traditional methods.
In Release 20, 3GPP began studying approaches for developing 6G mobile communication technologies. This paper aims to systematize the solutions considered in 3GPP by August 2026, compare them with 5G mechanisms, and assess their maturity. The analysis covers design principles, the physical layer, radio access network architecture, integrated sensing methods, and energy-saving mechanisms. Particular attention is paid to the native integration of artificial intelligence: the paper traces the transition from individual machine learning functions in 5G-Advanced to a common framework for data collection, model inference, monitoring, and lifecycle management. For each area, the paper distinguishes solutions supported during the study phase, solutions under discussion, and proposals from individual companies. Available quantitative evaluations are presented, and open problems are identified in cross-vendor model interoperability, reproducibility, robustness, radio resource sharing, and energy consumption.