Design of battery charging system on solar tracker based PV system and its application has been presented in this paper. To improve the system performance, a solar tracking system as an innovative device of PV has been developed with an intelligent controller. PV equipped by solar tracker can significantly enhace its performance up to 40% of conventional system. In this research solar tracker designed has active tracking mode with double axis. In order to keep the PV performance optimum, a smart battery charging system has been developed and provided to store the electricity generated by PV system. A novel algorithm was implemented to the system which allows the battery charging process to operate quickly and safely. Besides, the components involved in the system are DC-DC converter, sensor, actuator and battery. DC-DC Converter used is Single Ended Primary Inductance Mode (SEPIM) with MOSFET as its actuator. Battery charging system has used intelligent control based on fuzzy-PSO algorithm. In this case, PSO functions to optimize and modify fuzzy parameters to obtain the best model. Optimized fuzzy controller has then been implemented and programmed in an Arduino microcontroller module to generate control signal which commands actuator element to control the voltage of battery through duty cycle manipulation variable. This algorithm has been able to improve the solar charging controller significantly and more convincingly increase PV performance.
World energy consumption increases with time, so that occur an energy imbalance. Many breakthroughs have developed to utilize renewable energy. The photovoltaic system is one of the easy-to-use renewable energies. The power conversion from PV fixed is still low, so the PV system is designed using the active dual-axis solar tracker. The PV tracker position can be adjusted to change the sun position to get maximum efficiency. The active dual-axis solar tracker system is integrated with the maximum power point tracking (MPPT) algorithm to keep PV operating at a maximum power point even though input variations change. The active dual-axis solar tracker system integrated with the maximum power point tracking (MPPT) algorithm to keep PV operating at a maximum power point even though input variations change. Tracking test simulation had done by comparing the output power of a fixed PV system with the active dual-axis solar tracker. Type-2 fuzzy logic based MPPT successfully increased the average output power by 10.48 % with the highest increase of 17.48 % obtained at 15:00 West Indonesia Time (GMT+7). The difference in power from a fixed PV system with the active dual-axis solar tracker of 36.08 W is from the output power worth 206.3 to 242.4 W.
31 August 2022 in International Review on Modelling and Simulations (IREMOS)
Solar panels are the main component of solar power generation systems, and they function by converting solar energy into electrical energy. Indonesia has great potential for solar energy. Solar panels will work optimally at temperatures of 25 °C to 28 °C. The greater the temperature of the solar panel, the more power generated by the panel. The influence of solar radiation intensity can be caused by dust and animal droppings attached to the surface of the solar panel module. If the surface of a solar panel is covered with dust or dirt, which can block the entry of solar radiation, the resulting power output is not optimal. The aim of this research is to design and implement an automatic cleaning system for solar power plants. The system used is using ESP32 based on the Blynk application and adding internet of things (IoT) devices with a cleaning method using pumped water spraying, then assisted with wipers which have silicon rubber material to clean dust and dirt. Based on the cleaning optimization simulation calculations, we found that the optimal or efficient cleaning condition was once a month, with an efficiency of 75.17%.
Solar energy is one of the renewable energy that gets more attention from many countries. Solar photo voltaic (PV) takes the right position to get the maximum energy yield. The study was conducted by comparison of performance with two methods of tracking the sun with one axis and two axes by using ANFIS control (Adaptive Neuro-Fuzzy Inference System). The solar tracking system is a system that operates on the sun by using a light sensor and controls the photovoltaic to always perpendicular to the sun by changing the pitch and yaw axis of the sun tracing properties. LDR (Light Dependent Resistor) is one of the light sensors whose resistance changes depending on the intensity of incoming light. Direct current (DC )motor is used as a PV drive panel in a solar tracking system. A two-axis solar tracking system has a greater power output than a tracking system with a single photovoltaic panel that does not use a tracking system (fixed).
1 June 2023 in International Journal of Electrical and Computer Engineering (IJECE)
One obstacle to the energy industry’s tendency toward adopting renewable energy is the requirement for a monitoring system for energy transactions based on microgrids in the wheeling scheme (shared use of utility networks). The quantity of transaction expenses for each operational generator is not monitored in any case. In this project, a mobile phone application is developed and maintained to track the total amount of fees paid and received by all wheeling parties and the amount of electricity produced by the microgrid. In the wheeling case system research, the number of transaction costs, such as network rental fees, loss costs, and profit margins, must be pretty calculated for all wheeling participants. The approach created in this study uses a blockchain system to execute transactions, and transactions can only take place if the wheeling actor and the generator have an existing contract. The application of energy trading is the main contribution of this research. The created application may track energy transfers and track how many fees each wheeling actor is required to receive or pay. Using a security system to monitor wheeling transactions will make energy trades transparent.