In order to support the operation of ITER and the planned experimental programme an extensive set of plasma and first wall measurements will be required. The number and type of required measurements will be similar to those made on the present-day large tokamaks while the specification of the measurements—time and spatial resolutions, etc—will in some cases be more stringent. Many of the measurements will be used in the real time control of the plasma driving a requirement for very high reliability in the systems (diagnostics) that provide the measurements. The implementation of diagnostic systems on ITER is a substantial challenge. Because of the harsh environment (high levels of neutron and gamma fluxes, neutron heating, particle bombardment) diagnostic system selection and design has to cope with a range of phenomena not previously encountered in diagnostic design. Extensive design and R&D is needed to prepare the systems. In some cases the environmental difficulties are so severe that new diagnostic techniques are required. a Author to whom any correspondence should be addressed.

Spontaneous formation of an internal transport barrier was observed associated with improved confinement in the high-${\mathrm{\beta }}_{\mathit{p}}$ discharges in the JT-60U tokamak. The radial location of the transport barrier was found to be on the q=3 surface. A fast magnetohydrodynamic event localized at the transport barrier triggered the subsequent formation of an edge transport barrier that resulted in the further confinement improvement. In these discharges, a high poloidal rotation velocity that significantly exceeded the prediction of the present neoclassical theory was also observed at r/a=0.8.

The design progress in a compact low aspect ratio (low A) DEMO reactor, ‘SlimCS’, and its design issues are reported. The design study focused mainly on the torus configuration including the blanket, divertor, materials and maintenance scheme. For continuity with the Japanese ITER-TBM, the blanket is based on a water-cooled solid breeder blanket. For vertical stability of the elongated plasma and high beta access, the blanket is segmented into replaceable and permanent blankets and a sector-wide conducting shell is arranged inbetween these blankets. A numerical calculation indicates that fuel self-sufficiency can be satisfied when the blanket interior is ideally fabricated. An allowable heat load to the divertor plate should be 8 MW m⁻² or lower, which can be a critical constraint for determining a handling power of DEMO.

Peak fusion power production of 6.2±0.4 MW has been achieved in TFTR plasmas heated by deuterium and tritium neutral beams at a total power of 29.5 MW. These plasmas have an inferred central fusion alpha particle density of 1.2×${10}^{17}$ ${\mathrm{m}}^{\mathrm{-}3}$ without the appearance of either disruptive magnetohydrodynamics events or detectable changes in Alfvén wave activity. The measured loss rate of energetic alpha particles agreed with the approximately 5% losses expected from alpha particles which are born on unconfined orbits.