Daniel Evlogiev

Dr. Daniel Evlogiev


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
26 May 2022 in Processes
Verified
Journal Article
Open access
PDF file
RZRoumiana Zaharieva
Roumiana Zaharieva
DEDaniel Evlogiev
Daniel Evlogiev
NKNikolay Kerenchev
Nikolay Kerenchev
TSTsveta Stanimirova
Tsveta Stanimirova
Foundation of buildings in soft soil such as quaternary clay is often associated with difficult compaction, settlement, non-uniform and/or excessive deformation, and unsatisfactory shear resistance. The present study aims to assess the possibility of using recycled fines from construction and demolition waste, such as mechanically treated gypsum and waste concrete powder (WCP), instead of ordinary binders or industrial waste, in the stabilization of quaternary clay. A detailed characterization of soil components is presented. Seven mixes with various proportions of gypsum and WCP are prepared. Main geotechnical parameters of the modified soil are studied by applying standardized methods with a few deviations. XRD analysis and pH measurements are performed. It was found that the effect of 5% to 20% recycled di-hydrate gypsum is limited to improvement in moist soil compatibility. A gypsum content of 10% positively impacts soil cohesion and the oedometer modulus. WCP is an active component, containing non-hydrated cement, portlandite, calcite and calcium silicates hydrate. As a result, by adding 5% of WCP only, significant improvement can be achieved: greater soil cohesion, reduced deformability and higher UCS. When 5% of recycled gypsum is also added, soil cohesion is further improved because of ettringite formation.

1 April 2026 in IOP Conference Series: Materials Science and Engineering
Verified
Conference Paper
Open access
DEDaniel Evlogiev
Daniel Evlogiev
RZRoumiana Zaharieva
Roumiana Zaharieva
Recycled brick aggregate (RBA) offers structural concrete with reduced dead load and improved thermal insulation. However, RBA affects the rheological properties of fresh concrete due to its high porosity and water absorption, rough surface and irregular shape compared to natural aggregates. The aim of this study is to propose an optimized moisture content of RBA, allowing to achieve the desired performance of the fresh and hardened concrete. Six concrete mixtures are investigated, in which laboratory-produced RBA replaces fifty percent of the natural coarse aggregate. The behaviour of the RBA concrete is compared with that of a reference concrete made only from natural crushed stone. The initial moisture content of RBA is 0%, 4.2%, 8.4%, 12.6%, 14.7% and 16.8%, where the latter value corresponds to the 24-hour water absorption. The rheological parameters are evaluated using an ICAR Plus concrete rheometer. Workability is measured using slump test and flow table test. Changes in the rheological behaviour of fresh concrete are recorded during the first hour after mixing. Compressive strength is tested based on cubic samples at the age of 7, 28, 60, and 90 days. As expected, the rheological behaviour of fresh concrete with RBA is significantly affected by the RBA’s moisture content. The optimum moisture content of RBA seems to be about 80% of the water absorption value: then the rheological parameters are close to those of the reference mix and the workability can be maintained satisfactorily for at least 60 minutes. The kinetics of the compressive strength of the different mixes is not greatly affected by the initial moisture of RBA.

12 March 2026 in Processes
Verified
Journal Article
Open access
PDF file
RZRoumiana Zaharieva
Roumiana Zaharieva
DEDaniel Evlogiev
Daniel Evlogiev
NDNikolay Dinov
Nikolay Dinov
Asbestos-containing materials (ACMs) are among the most common types of hazardous building materials. Usually, ACMs are identified by laboratory methods, which can slow down and complicate the processes of demolition and refurbishment of old buildings. The hypothesis applied in this study is that ACMs, both in friable and non-friable forms, can be reliably identified in situ using a handheld Raman spectrometer (HHRS). A HHRS equipped with two temperature-controlled diode lasers (785 nm and 852 nm) was used. Two groups of ACMs were examined: one, consisting of ACMs with a known type of asbestos, previously determined by standardised tests used for the HHRS method’s validation, and the second, consisting of presumed ACMs, where HHRS was used for the identification of asbestos. Additional testing according to ISO 22262-1 was applied. The impact of several factors on the asbestos identification was evaluated. The results confirm that the identification by HHRS of all main types of asbestos minerals is possible with a certain level of probability, regardless of whether the fibres are in an unbound form (fabrics, ropes, wools) or bound within cementitious or polymer composites. Some processing (scaling, smoothing) of the reference spectra should be applied to increase the percentage of asbestos minerals’ identification. In conclusion, it has been proven that the majority of ACM in buildings may be identified in situ by HHRS in a rapid manner, thus accelerating the pre-demolition/pre-renovation audit (PDA/PRA), avoiding risks to demolition/refurbishment workers’ health due to asbestos unawareness, as well as preventing the contamination of other CDW and environmental pollution.