Severe plastic deformation (SPD) is known to be the best method for producing bulk ultrafine-grained and nanostructured materials with excellent properties. Different SPD methods were developed that are suitable for sheet and bulk solid materials. During the past decade, efforts have been made to create effective SPD processes suitable for producing cylindrical tubes. In this paper, we review SPD processes intended to produce ultrafine-grained and nanostructured tubes, and their effects on material properties. The paper will focus on introduction of the tube SPD processes, and then comparison of them based on their advantages and disadvantages from the viewpoints of processing and properties.
9 July 2024 in Journal of Materials Research and Technology
In this study, dissimilar joints of AA5083-H116 and AA7075-T6 aluminum alloys were successfully made by friction stir welding technique. The microstructure and mechanical behavior of the welded joints were investigated at different rotational and traverse speeds. A mathematical modeling was developed to demonstrate a relationship between the friction stir welding parameters and the ultimate tensile strength of the dissimilar joints. Then, the mathematical modeling was optimized by genetic algorithm in order to find the optimum condition in which the maximum tensile strength of welded joints can be achieved. Eventually, genetic algorithm results confirmed that the maximum tensile strength of welded joints is achievable in rotational and traverse speeds of 500 r/min and 50 mm/min, respectively. The maximum error between experimental data and predicted model was less than 1%.
1 March 2012 in Materials and Manufacturing Processes
Accumulative back extrusion (ABE) is a recently developed severe plastic deformation process. In this article, the effects of deformation ratio (inner punch diameter/outer punch diameter) employed for ABE on the microstructure, grain size distribution, and Mg17Al12 phase precipitation in AZ91 magnesium alloys were investigated. The results showed that the deformation ratio has significant effect on the microstructure of processed material. Also, increasing in the deformation ratio leads to better microstructure homogeneity, more grain refinement, and more Mg17Al12 precipitation. Quantitative grain size value showed that the minimum grain size value corresponds to the center zone of ABE processed sample with higher deformation ratio. The massive Mg17Al12 precipitates remaining in the matrix increase by decreasing the deformation ratio. Microhardness observation verified the microstructure results.