The fuel for fungal enzymes: Many microorganisms have specialized enzymes to target and break down plant biomass. In fungi, these enzymes, called lytic polysaccharide monooxygenases (LPMOs), partner with electron transfer partners to oxidatively cleave the polysaccharide backbone of lignocellulosic polymers. Kracher et al. examined several potential extracellular electron transfer partners for LPMO, including other enzymes and small redoxactive metabolites (see the Perspective by Martínez). All three were able to donate electrons to the single-copper active site. Such versatility helps these fungi adapt to a range of redox conditions and potentially use other extracellular electron donors to fuel biomass degradation. Science , this issue p. 1098 ; see also p. 1050

Lytic polysaccharide monooxygenases (LPMO) release a spectrum of cleavage products from their polymeric substrates cellulose, hemicellulose, or chitin. The correct identification and quantitation of these released products is the basis of MS/HPLC-based detection methods for LPMO activity. The duration, effort, and intricate analysis allow only specialized laboratories to measure LPMO activity in day-to-day work. A spectrophotometric assay will simplify the screening for LPMO in culture supernatants, help monitor recombinant LPMO expression and purification, and support enzyme characterization. Based on a newly discovered peroxidase activity of LPMO, we propose a fast, robust, and sensitive spectrophotometric activity assay using 2,6-dimethoxyphenol (2,6-DMP) and H2O2. The fast enzymatic assay (300 s) consists of 1 mM 2,6-DMP as chromogenic substrate, 100 µM H2O2 as cosubstrate, and an adequate activity of LPMO in a suitable buffer. The high molar absorption coefficient of the formed product coerulignone (ε469 = 53,200 M−1 cm−1) makes the assay sensitive and allows reliable activity measurements of LPMO in concentrations of approx. 0.5–50 mg L−1. The activity assay based on 2,6-DMP detects a novel peroxidase activity of LPMO. This activity can be accurately measured and used for enzyme screening, production, and purification, and can also be applied to study binding constants or thermal stability. However, the assay has to be used with care in crude extracts, because other enzymes such as laccase or peroxidase will interfere with the assay. We also want to stress that the peroxidase activity is a homogeneous reaction with soluble substrates and should not be correlated to heterogeneous LPMO activity on polymeric substrates.

Fungal high redox potential laccases are proposed as cathodic biocatalysts in implantable enzymatic fuel cells to generate high cell voltages. Their application is limited mainly through their acidic pH optimum and chloride inhibition. This work investigates evolutionary and engineering strategies to increase the pH optimum of a chloride-tolerant, high redox potential laccase from the ascomyceteBotrytis aclada. The laccase was subjected to two rounds of directed evolution and the clones screened for increased stability and activity at pH 6.5. Beneficial mutation sites were investigated by semi-rational and combinatorial mutagenesis. Fourteen variants were characterised in detail to evaluate changes of the kinetic constants. Mutations increasing thermostability were distributed over the entire structure. Among them, T383I showed a 2.6-fold increased half-life by preventing the loss of the T2 copper through unfolding of a loop. Mutations affecting the pH-dependence cluster around the T1 copper and categorise in three types of altered pH profiles: pH-type I changes the monotonic decreasing pH profile into a bell-shaped profile, pH-type II describes increased specific activity below pH 6.5, and pH-type III increased specific activity above pH 6.5. Specific activities of the best variants were up to 5-fold higher (13 U mg⁻¹) thanBaL WT at pH 7.5.

Background: The availability of a sensitive and robust activity assay is a prerequisite for efficient enzyme production, purification, and characterization. Here we report on a spectrophotometric assay for lytic polysaccharide monooxygenase (LPMO), which is an advancement of the previously published 2,6-dimethoxyphenol (2,6-DMP)-based LPMO assay. The new assay is based on hydrocoerulignone as substrate and hydrogen peroxide as cosubstrate and aims toward a higher sensitivity at acidic pH and a more reliable detection of LPMO in complex matrices like culture media. Results: An LPMO activity assay following the colorimetric oxidation of hydrocoerulignone to coerulignone was developed. This peroxidase activity of LPMO in the presence of hydrogen peroxide can be detected in various buffers between pH 4–8. By reducing the substrate and cosubstrate concentration, the assay has been optimized for minimal autoxidation and enzyme deactivation while maintaining sensitivity. Finally, the optimized and validated LPMO assay was used to follow the recombinant expression of an LPMO in Pichia pastoris and to screen for interfering substances in fermentation media suppressing the assayed reaction. Conclusions: The biphenol hydrocoerulignone is a better substrate for LPMO than the monophenol 2,6-DMP, because of a ~ 30 times lower apparent K_M value and a 160 mV lower oxidation potential. This greatly increases the measured LPMO activity when using hydrocoerulignone instead of 2,6-DMP under otherwise similar assay conditions. The improved activity allows the adaptation of the LPMO assay toward a higher sensitivity, different buffers and pH values, more stable assay conditions or to overcome low concentrations of inhibiting substances. The developed assay protocol and optimization guidelines increase the adaptability and applicability of the hydrocoerulignone assay for the production, purification, and characterization of LPMOs.

Lytic polysaccharide monooxygenases (LPMOs) are ubiquitous oxidoreductases, facilitating the degradation of polymeric carbohydrates in biomass. Cellobiose dehydrogenase (CDH) is a biologically relevant electron donor in this process, with the electrons resulting from cellobiose oxidation being shuttled from the CDH dehydrogenase domain to its cytochrome domain and then to the LPMO catalytic site. In this work, we investigate the interaction of four Neurospora crassa LPMOs and five CDH cytochrome domains from different species using computational methods. We used HADDOCK to perform protein–protein docking experiments on all 20 combinations and subsequently to select four complexes for extensive molecular dynamics simulations. The potential of mean force is computed for a rotation of the cytochrome domain relative to LPMO. We find that the LPMO loops are largely responsible for the preferred orientations of the cytochrome domains. This leads us to postulate a hybrid version of NcLPMO9F, with exchanged loops and predicted altered cytochrome binding preferences for this variant. Our work provides insight into the possible mechanisms of electron transfer between the two protein systems, in agreement with and complementary to previously published experimental data.

Lytic polysaccharide monooxygenases (LPMOs) are widely distributed in fungi, and catalyze the oxidative degradation of polysaccharides such as cellulose. Despite their name, LPMOs possess a dominant peroxygenase activity that is reflected in high turnover numbers but also causes deactivation. We report on the influence of small molecules and ions on the activity and stability of LPMO during catalysis. Turbidimetric and photometric assays were used to identify LPMO inhibitors and measure their inhibitory effect. Selected inhibitors were employed to study LPMO activity and stability during cellulose depolymerization by HPLC and turbidimetry. It was found that the fungal metabolic products oxalic acid and citric acid strongly reduce LPMO activity, but also protect the enzyme from deactivation. QM calculations showed that the copper atom in the catalytic site could be ligated by bi- or tridentate chelating compounds, which replace two water molecules. MD simulations and QM calculations show that the most likely inhibition pattern is the competition between the inhibitor and reducing agent in the oxidized Cu(II) state. A correlation between the complexation energy and the IC₅₀ values demonstrates that small, bidentate molecules interact strongest with the catalytic site copper and could be used by the fungus as physiological effectors to regulate LPMO activity.