Pipeline leakage seriously threatens the efficient and safe gas drainage in coal mines. To achieve the accurate detection and localization of gas drainage pipeline leakages, this study proposes a gas drainage pipeline leakage detection and localization approach based on the pressure gradient method. Firstly, the basic law of gas flow in the drainage pipeline was analyzed, and a pipeline network resistance correction formula was deduced based on the pressure gradient method. Then, a drainage pipeline model was established based on the realizable turbulence model, and the pressure and flow velocity distribution during pipeline leakage under different leakage degrees, leakage locations, and pipeline negative pressures were simulated and analyzed, thus verifying the feasibility of the pipeline leakage detection and localization method. It is concluded that the positioning errors of pipeline leakage points under different leakage degrees, different leakage positions, and different pipeline negative pressures were 0.88~1.08%, 0.88~1.49%, and 0.68~0.88%, respectively. Finally, field tests were conducted in the highly located drainage roadway 8421 of the Fifth Mine of Yangquan Coal Industry Group to verify the accuracy of the proposed pipeline leakage detection and localization method, and the relative error was about 8.2%. The results show that with increased pipeline leakage hole diameters, elevated pipeline negative pressures, and closer leakage positions to the pipeline center, the relative localization error was smaller, the localization accuracy was higher, and the stability was greater. The research results could lay the foundation for the fault diagnosis and localization of coal mine gas drainage pipeline networks and provide technical support for safe and efficient coal mine gas drainage.
The rapid desorption of gas in coal is an important cause of gas over-limit and outbursts. In order to explain the causes of coal and gas outbursts induced by vibration, this paper studies the gas desorption experiments of tectonic coal with different particle sizes and different adsorption equilibrium pressures under 0~50 Hz vibration. High-pressure mercury intrusion experiments were used to measure the changes in pore volume and specific surface area of tectonic coal before and after vibration, revealing the control of pore structure changes on the initial desorption capacity of gas. Additionally, from the perspective of energy transformation during coal and gas outbursts, the effect of vibration on the process of coal and gas outbursts in tectonic coal was analyzed. The results showed that tectonic coal has strong initial desorption capacity, desorbing 29.58% to 54.51% of the ultimate desorption volume within 10 min. Vibration with frequencies of 0~50 Hz increased both the gas desorption ratios and desorption volume as the frequency increased. The initial desorption rate also increased with the vibration frequency, and vibration can enhance the initial desorption capacity of tectonic coal and delay the attenuation of desorption rate. Vibration affected the changes in the initial gas desorption rate and desorption rate attenuation coefficient by increasing the pore volume and specific surface area, with the changes in macropores and mesopores primarily affecting the initial desorption rate and 0~10 min desorption ratios, while the changes in micropores and minipores mainly influenced the attenuation rate of the desorption rate. Vibration increased the free gas expansion energy of tectonic coal as the frequency increased. During the incubation and triggering processes of coal and gas outbursts, vibration has been observed to accelerate the fragmentation and destabilisation of the coal body, while simultaneously increasing the gas expansion energy to a point where it reaches the threshold energy necessary for coal transportation, thus inducing and triggering the coal and gas protrusion. The study results elucidate, from an energy perspective, the underlying mechanisms that facilitate the occurrence of coal and gas outbursts, providing theoretical guidance for coal and gas outburst prevention and mine safety production.
Coal and gas outburst is one of the most disasters threating the safety and production of coal mines. Accurate description of the gas emission characteristics in the initial stage for tectonic coal is the key to improving the prediction accuracy of coal and gas outburst. In this work, the gas emission test of original and tectonic coal particles under the constant temperature was carried out. The optimal mathematical model suitable for the gas emission in the initial stage was then analyzed. Moreover, the time influencing factors of the optimal mathematical model were discussed. The research results show that cumulative gas desorption amount during 0-7 minute for tectonic coal is 1.28-1.41 times as much as that for original coal. The applicability of current mathematical model for describing the gas emission characteristics of tectonic coal in the initial stage has limitations. Five typical mathematical expressions are selected and compared to fit gas emission curve in the initial stage. Considering the sensitivity of parameters in outburst prediction, the optimal mathematical model was obtained. In addition, the time factor has a great influence on the application effect of mathematical model in coal and gas outburst prediction. For current mathematical model, the errors of tectonic coal are all negative. The greater the gas pressure and the later the measurement time, the greater the error. The errors in 1~6 min are -0.46%~-1.78%, and the errors in 2~7 min are -1.00%~-3.86%, which is not conducive to the safety of outburst prediction. Therefore, the optimal mathematical model has the possibility to overcome the limitations of current mathematical model. The research results provide a theoretical basis for the correction of coal and gas outburst prediction indicators.