A multi-core model, i.e. a simplified term of a multi-layered core model, is proposed as a working hypothesis to understand various properties and phenomena that polymer nanocomposites exhibit as dielectrics and electrical insulation. It gives fine structures to what are called "interaction zones". An interfacial layer of several tens nm is multi-layered, which consists of a bonded layer, a bound layer, and a loose layer. In addition, the Gouy-Chapman diffuse layer with the Debye shielding length of several tens to 100 nm is superimposed in the interfacial layer to cause a far-field effect. Nano-particles may interact electrically with the nearest neighbors each other due to this effect, resulting in possible collaborative effect. Such a multi-core model with the far-field effect is discussed, for example, to explain partial discharge (PD) resistance of polyamide layered silicate nanocomposites, and is verified to demonstrate its effectiveness.
1 November 2004 in IEEE Transactions on Dielectrics and Electrical Insulation
Partial discharge (PD) degradation of polyamide both without nanoscale fillers (nanofillers) and with 2,4 and 5 wt% additions of nanofillers was investigated. Such materials were subjected to PDs using the IEC (b) electrodes for evaluation. Comparisons were made as to the surface roughness observed by scanning electron microscopy and atomic force microscopy. It was found that the change in the surface roughness is far smaller in specimens with nanofillers than those without nanofillers, and that the 2 wt% addition is sufficient for improvement of the surface roughness. Furthermore, it was elucidated that the difference of surface roughness of the degraded area due to PDs among the specimens originates from the difference in their crystalline structures. These results indicate that polyamide nanocomposite is more resistance to PDs than polyamide without nanofillers.
11 February 2013 in IEEE Transactions on Dielectrics and Electrical Insulation
Effects of nanofiller materials on typical dielectric properties of bisphenol-A epoxy resin were compared among three kinds of nanofillers, i. e. boehmite alumina, titania, and silica. In all the samples, the complex permittivity εr' and εr" become significantly higher with an increase in temperature beyond 120 °C, especially at low frequencies. Such increase in εr' and εr" indicates the abundance of mobile charge carriers, which was verified by the space charge distribution measurements. All the samples show two peaks at 110 and 180 °C in the thermally stimulated depolarization current spectra. The lower-temperature peak is apparently caused by depolarization of dipoles induced by the glass transition, while the higher-temperature peak is due to the release of space charge. These characteristic properties appear more significantly in the nanocomposites with boehmite alumina and titania and less significantly in the nanocomposite with silica than in the neat epoxy esin. This indicates that the silica nanofillers give the best results as far as these properties cconcerned. The suppression of molecular motion by the addition of nanofillers seems to work effectively in the case of silica, while the nanofiller addition is likely to aaccelerate the motion of ionic carriers and/or that of dipoles in the case of boehmite alumina and titania.
7 February 2008 in IEEE Transactions on Dielectrics and Electrical Insulation
Degradation profiles induced by partial discharges and those induced by oxygen plasmas are compared for polyamide/mica nanocomposites. Both the resistances to partial discharges and to plasmas improve with an increase in nanofiller content. On the other hand, the partial discharge resistance is not improved if mum-sized glass fibers are added to polyamide. In order to investigate these phenomena, the superior resistance mechanism of nanocomposites is discussed, focusing on the effects of the nanofillers on the bulk and surface structures of the resin. It was revealed from X-ray diffraction and permittivity measurements that the nanofiller loading increases crystallinity of the resin and restricts the molecular motion. This should enhance the resistance to degradation. Furthermore, observation results by scanning electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction revealed that the nanofillers had piled up themselves to form a layered structure on the sample surface in an early stage of degradation. Such a structure acts as a barrier against impact of charged particles and diffusion of gases such as oxygen, which should contribute to the improvement of resistance to degradation as its direct effect and also as its indirect effect by suppressing the oxidation of resin. Moreover, it was also revealed from scanning electron microscopy that the nanofillers impede the growth of surface cavities by partial discharges drastically.
1 October 2010 in Japanese Journal of Applied Physics
Terahertz (THz) spectra were obtained for polylactide, and they were analyzed by numerical calculations based on density functional theory. An absorption band was observed at approximately 50 cm-1, which becomes larger when the THz electric field is parallel to the sample drawing direction. An absorption peak with a similar directional dependence appears at approximately 40 cm-1 in the simulation, which is due to normal-mode molecular vibrations parallel to the molecular helix. Since the 50 cm-1 absorption decreases with an increase in crystallinity and the permittivity shows a step-like decrease, the molecular vibrations responsible for the 50 cm-1 band seem to be subjected to strong damping in amorphous regions. On the other hand, another absorption peak at 65 cm-1 with a positive absorption dependence on the sample's crystallinity is likely to be due to lattice vibration, since it does not appear in the calculations, which only deal with intramolecular vibration.
14 July 2011 in IEEE Electrical Insulation Magazine
Spectroscopic and imaging analyses using electromagnetic waves in the far IR or submillimeter region [0.1-20 terahertz (THz)] are emerging technologies in the field of optics research. Thanks to recent advances in related science and technology [l]-[6], it has been proposed that THz technology be applied in many fields such as early diagnosis of cancer, detection of counterfeit bills, and moisture analysis.