Indium tin oxide (ITO) films are widely used as transparent conducting electrodes in solar cells, gas sensors, and car windows because of their high electrical conductivity and good optical transparency in the visible region. In this work, ITO thin films were prepared by cathodic radio‐frequency (RF) sputtering using an ITO target with 90% In2O3 and 10% SnO2. The structural properties were studied by X‐ray diffraction (XRD), scanning electronic microscopy (SEM), and X‐ray reflectometry (XRR). Electrical measurements were performed by applying the four‐point method and studying the Hall Effect. Finally, optical properties were taken by the UV‐Vis‐NIR spectrophotometry. The effect of the RF power and deposition time on optical and electrical properties was investigated. It is shown that by using a RF power of 110–80 W, one can prepare crystalline samples with low resistivity, which is an aimed property for TCO semiconductors. Electrical measurements revealed that the resistivity decreases by increasing the RF power and/or the deposition time.
An uneven-span modified greenhouse dryer was constructed and tested in no-load conditions under natural convection mode under the weather conditions of Marrakech, Morocco, for two distinct days. Moreover, a CFD evaluation of the uneven-span greenhouse dryer was performed as tool to visualize the air temperature distribution inside the dryer. For validating the CFD model, the temperature variations along the hours of the day were compared to the experimental results. A good agreement is obtained between the computed and measured inside air temperature with a difference not exceeding 8.46°C, with a correlation coefficient () and root mean square percentage deviations () 0.94 and 8.17, respectively. Furthermore, the maximum inside air temperature was measured to be 56°C and 52°C while the minimum inside relative humidity was measured to be 17% and 12%, for day-1 and day-2, respectively. The benefice of using asphalt as a floor covering material was revealed as an efficient way to heat the inside air at low solar radiations. The performances of the dryer were evaluated by the percentage of net heat gain variation as a way to validate the effectiveness of the dryer. This latter is found to be equal to 46% and 48% for the two days, respectively.
29 October 2019 in Journal of Electronic Materials