Purpose: The purpose of this paper is to identify the main reworks and their causes in a case study of the ongoing mass housing project in Iran. Using the real data captured from the project, the most important causes for reworks have been computed and prioritized. Design/methodology/approach: More than 900 non-conformance forms filled in the construction site have been used to categorize reworks. Then, the frequency and cost of each rework group in the project have been estimated. Finally, using these data, the primary classification and sorting of the main causes of reworks have been specified. Findings: Results show “Poor site supervision and inspection” with 24 percent of costs had the most impact and “unclear project management process” with about 6 percent of costs had the least impact on the formation of non-conformances. “Cost of each incidence” (COI) ranged from 0.67 for “The need to categorize the complicated operations” to 1.86 for “Unclear project management process.” Research limitations/implications: The causes of rework which are not in contractor’s hand (like change orders from the client) have not been considered in this study. Originality/value: Although some works have been done in rework causes, the key elements and causes of reworks in mass housing projects in developing countries have not been yet fully specified through the real data. Knowing the root causes of reworks can help project managers to remove them and reduce reworks costs in future projects. COI which is defined here for the first time and computed in a relative concept could be a good criterion to compare rework causes between two or more similar projects.
21 April 2020 in Iranian Journal of Science and Technology, Transactions of Civil Engineering
Nowadays, the use of steel plate shear walls, as an effective seismic resisting system, has been of great interest in enhancing the lateral strength and stiffness of buildings both in renovation and seismic rehabilitation of existing concrete and steel structures. In the present research, the shear strength and stiffness of steel plate shear walls in various configurations of stiffeners, including horizontal, vertical, and horizontal–vertical, were investigated by finite element method and finally semi-empirical relations were presented in this regard. The results indicated that the shear strength and stiffness of stiffened SPSWs were well predicted by the proposed relations, but increasing the number of stiffeners above a certain range will not have a significant effect on enhancing the stiffness and strength.
16 July 2021 in International Journal of Mechanics and Materials in Design
This paper studies the impact of temperature rise on the performance of Concrete-Filled Double Skin Tubular Steel Columns with prismatic geometry. In doing so, several columns whose interior cores were square, diamond, and circularly shaped and whose exterior cores were prismatic with a square cross-sectional area that increases with the slope of 2.1 degrees from top to the bottom, were constructed and exposed to the temperatures of 25°C, 250°C, 500°C, and 700°C. Afterward, all column specimens were subjected to cyclic loads adopted from the Applied Technology Council (ATC)-24 loading protocol, which proceeded until the specimens failed to further carry loads. The results indicate that although the failure modes of the columns with an interior core of a square or diamond shape are similar to each other, the columns whose interior cores were circularly shaped experienced more intensive damages compared to the others. The base of the columns was fractured diagonally with a degree of 45 by the temperature of 500°C, but at 700°C, the damages have occurred horizontally at the height of 10 cm from the column base. Moreover, the initial stiffness and ductility ratio of the columns with a diamond-shaped interior core was approximately two times greater than the other columns.