Ombrotrophic peatlands contain a very small percentage of mineral matter that they receive exclusively from atmospheric deposition. Mineral matter deposited on the Šijec bog was characterized using scanning electron microscopy coupled with energy dispersive spectroscopy (SEM/EDS). We collected solid atmospheric deposition from snow, rainwater, and using passive samplers. Samples were collected at average atmospheric conditions and after two dust events. Size, morphology, and chemical composition of individual particles were determined. We distinguished four main particle groups: silicates, carbonates, organic particles, and Fe-oxyhydroxides. Silicate particles are further divided into quartz and aluminosilicates. Proportions of these groups vary between samples and between sample types. In all samples, silicate particles predominate. Samples affected by dust events are richer in solid particles. This is well observed in passive deposition samples. Carbonates and organic particles represent smaller fractions and are probably of local origin. Iron-oxyhydroxides make up a smaller, but significant part of particles and are, according to their shape and chemical composition, of both geogenic and anthropogenic origin. Estimated quantity and percentage of main groups vary throughout the year and are highly dependent on weather conditions. Dust events represent periods of increased deposition and contribute significantly to mineral matter input to peatlands.

Peatland hydrology plays an important role in preserving or changing the record in any consideration of past atmospheric deposition records in peat bogs. The Šijec bog, located on the Pokljuka plateau in Slovenia, is one of the largest ombrotrophic peatlands. We sampled the surface pools, pore water, drainage from the peatland, and karst streams not connected to the peatland. Additionally, we sampled the precipitation, as ombrotrophic peatlands receive mineral matter solely from the atmosphere. The results of the evaluation of the chemical and isotopic composition indicated different origins of dissolved mineral matter in different water types. The components originating from the bedrock and surrounding soils (Ca, Mg, Al, Si, Sr) predominated in the streams. The chemical composition of the peatland drainage water revealed the significant removal of major components from the peatland, particularly elements like Al, Fe, and REE, and metals that are readily dissolved in an acidic environment or mobile in their reduced state. Despite their solubility, concentrations of metals (As, Cr, Cu, Fe, Ni, Pb, Ti) and REE in surface pools remained higher than in the drainage due to incomplete elimination from the peatland. The composition of pore water reflects variations among the W and E parts of the peatland, indicating a heterogenous hydrological structure with different dynamics, such as an additional source of water at approximately 90 cm depth in the NW part. The chemical composition and isotope signature (¹⁸O and ²H) of pore water additionally indicated a heterogeneous recharge with residence times of less than a year. The overall analysis indicated a predominantly ombrotrophic type and a small part in the NW area of the peatland as a minerotrophic type of peat.

Biathlon activities can have negative effects on the environment due to the processes occurring during shooting, as the biathlon ammunition contains significant amounts of Pb, Cu and Sb. To determine these effects, we looked into the presence of lead-bearing particles in the vicinity of a shooting range in Rudno polje, Pokljuka, in Slovenia. Particles were collected from snow and later analysed using SEM/EDS, where we focused on the lead-bearing particles. These particles are composed of mainly lead or lead oxides/hydroxides with trace presence of Cu and Sb, both of which are commonly related to ammunition used in biathlon shooting and other shooting activities. To confirm that the particles originated from shooting, we compared them with particles taken from an indoor shooting range as dust and residue in ammunition casings. Lead-bearing particles show morphological changes that are caused by high temperatures and pressures during the shooting process.