In this paper, multi-layer and multi-pass arc additive manufacturing experiments were carried out on the Q345 substrate using Y309L welding wire. Based on MSC. Marc software, a thermal-elastic-plastic finite element method was developed to numerically simulate the temperature field, stress field, and deformation during the additive manufacturing process. The effects of the substrate thickness and interpass temperature on the temperature field, stress field, and deformation were discussed. The results indicated that the deposition materials at different positions experienced different thermal cycles, which might lead to the non-uniform microstructure and mechanical properties within the workpiece. The interpass temperature and the thickness of the substrate influenced the residual stress distribution in the additive manufactured structure. A low interpass temperature and thin substrate was able to effectively reduce the tensile residual stress. The thick substrate resulted in a small angular deformation of the substrate during the additive manufacturing process.

In this study, SiCp/Al composites were bonded using the laser-induced exothermic bonding method. The nanostructured Al/Ni energetic materials were prepared by the high-energy ball-milling method and served as the bonding interlayer. The joint microstructure was characterized by SEM, EDS, TEM, and XRD. The effect of Zr content on the joint microstructure and shear strength was investigated. The results indicated that after the ball-milling process the Al and Ni particles underwent strong plastic deformations and were welded to each other, forming the nanostructured Al/Ni energetic materials with a lamellar structure. Compared with the raw powders, the location of the exothermic peak decreased by 42 K, and its exothermic performance was significantly improved. The exothermic reactions that occurred in the Al/Ni interlayer provided the required heat for the bonding process. Near the bonding interface, the interlayer could not react completely due to the cooling effect of the substrates, forming a mixture of residual metal particles and Ni-Al compounds. The addition of Zr content enhanced the interfacial reactions between the bonding interlayer and the SiCp/Al composites. The interlayer products transformed from NiAl to the eutectic organization of NiAl + Ni-Al-Zr, thus decreasing the pores in the joint and improving the bonding quality. With an increase in the Zr content, the joint shear strength first increased and then decreased. When the Zr content was 10 wt.%, the joint shear strength reached a maximum of 22 MPa.