The Green–Ampt (GA) model is a widely used analytical method to calculate the depth of the wetting front during intense rainfall. However, it neglects the existence of the transition layer and the seepage parallel to the slope surface. Therefore, a modified stratified Green–Ampt (MSGA) model is proposed. A process to assess the stability of the finite slope during a rainfall event is demonstrated by combining the MSGA model and the limit equilibrium method. In the case of the Liangshuijing landslide, the factor of safety presents a negative correlation with the depth of the wetting front. The factor of safety obtained by the stratified Green–Ampt (SGA) model is smaller than that calculated by the MSGA model, and the gap between the factor of safety based on the two methods widens with time. The moving speed of the wetting front accelerates with the increase in the length of the slope surface, and the size effect becomes apparent when the length is short. In the initial stage of infiltration, the effect of the seepage parallel to the slope surface is small. The effect of the seepage cannot be neglected at the latter stage. The result calculated by the MSGA model agrees well with the measured result in the test.
28 November 2022 in European Journal of Environmental and Civil Engineering
The discrete element method is used to study the deformation process and failure mechanism of rock masses under uniaxial compression when the initial joint frequency increases. In this study, a systematic analysis is carried out to investigate failure mechanisms in rock masses with special emphasis on macroscopic deformation processes and the micromechanical origin. The influences of joints on strength, deformability, stress–strain relationship, and failure mode are studied at the macroscopic level. The tensile and shear crack distribution, fragment characteristics, and energy dissipation are also analyzed to advance the understanding of the deformation process and failure mechanism of jointed rock masses. The microevolution of fabric and forces anisotropy during loading and contact force distribution provide insights into the effect of increasing initial joint frequency on the macroscopic deformation behavior of rocks. The results reveal that with the increasing initial joint frequency, the specimen exhibits brittle-ductile characteristics, and the failure mode changes from splitting to sliding along the joint surfaces. They also show how the deceleration in the growth of fabric and contact forces anisotropy develops and confirm that the increase in initial joints and corresponding microstructural changes can suppress the development of anisotropy, thereby significantly reducing the strength of rock samples.
2 September 2024 in Bulletin of Engineering Geology and the Environment