A simple, sensitive, accurate and inexpensive UV-reversed-phase high-performance liquid chromatographic method was developed for the determination of ascorbic acid in tablet formulations. The method was based on the separation of ascorbic acid using a mobile phase of an acetonitrile-NaH2PO4-H3PO4 buffer solution (pH = 3) (5:95 v/v) with a UV detection wavelength of 245 nm and a flow rate of 0.8 mL min−1 at ambient column temperature. The variables of the proposed method, such as acetonitrile fraction (%), flow rate (mL min−1) and column temperature (°C), were optimized on the peak area by response surface methodology via the Box–Behnken design. The mobile phase was passed isocratically, and the separation of ascorbic acid was performed at the retention time of 4.1 min. A calibration graph was obtained and found to be linear in the concentration range of 10–180 µg mL−1. The method suitability was assessed and an asymmetry factor of 1.15 was obtained. The proposed method was successfully applied for the determination of ascorbic acid in tablet formulations and statistically compared with the results of the reference method. The performance of the proposed method was excellent and in agreement with the reference method. The recovery percentage of the proposed and reference methods was in the range of 99.98–100.04% and showed compliance (100 ± 2%) with regulatory guidelines.
In this study, N-(((2-((2-aminoethyl)amino)ethyl)amino)methyl)-4-sulfamoylbenzamide was impregnated into the hydrous zirconium oxide matrix to yield N-(((2-((2-aminoethyl)amino)ethyl)amino)methyl)-4-sulfamoylbenzamide/hydrous zirconium oxide composite (AESB/HZO). The composite material was used to remove Ni(II) from aqueous environment. AESB/HZO was characterized using Fourier transform infrared, scanning electron microscopy with energy dispersive X-ray, and thermogravimetry–differential thermal analyses. An experimental design approach was utilized to model and optimize the variables of adsorption of Ni(II) onto the AESB/HZO composite. Four experimental parameters were selected as independent variables: contact time, pH, adsorbent dose, and initial Ni(II) concentration. A multivariable experimental design was used to establish quadratic model to describe the relationship between percent removal of Ni(II) and four independent variables. At the optimum conditions (contact time: 85 min, pH: 6, adsorbent dose: 10 mg/20 mL, and initial Ni(II) concentration: 20 mg L–1), high removal efficiency (99.35%) was achieved, which is reasonably well predicted by the quadratic model. The sorption of Ni(II) is dependent on pH and ionic strength at pH < 6.0. At low pH, −NH and −NH2 groups are protonated, whereas the −SO2– group is available for binding with Ni(II) and the sorption of Ni(II) is mainly governed by outer sphere surface complexation. In the pH range 6.0–7.5, −NH, −NH2, and −SO2– groups are available for binding with Ni(II) and the sorption is mainly governed by inner-sphere surface complexation. Adsorption isotherm data fitted well to the Langmuir model and the maximum adsorption capacity was found to be 96.03 mg g–1 at 303 K. The results of present investigation demonstrated that AESB/HZO has a good potential for Ni(II) removal from aqueous solution.