Due to the difference in surface reflectivity, the laser measurement waveform data recorded in full waveform have a saturation phenomenon. When the signal is saturated, the echo waveform produces peak clipping and pulse spreading, which seriously restrict the accuracy of laser measurement results and the usability of data. Therefore, we conducted a ranging investigation on the “peak clipping” phenomenon of the saturated waveform and found a nonlinear time delay in the range, which is between the two extreme cases of saturated “dead time” and Gaussian fitting peak time as pulse signal reception time. Subsequently, based on the consistent relationship between the geometric characteristics of the high- and low-gain channels of the space-borne laser altimeter, we constructed a laser waveform saturation compensation model, namely, the laser pulse flight time delay compensation and the laser waveform peak intensity compensation, and carried out the data saturation compensation and validation with the dual-channel measurement data from the GaoFen-7 (GF-7) satellite. The experimental results showed that the saturation compensation model (SCM) proposed in this paper could restore the features of the saturated waveform signal and effectively improve the accuracy of the laser ranging. The accuracy of the laser waveform fitting result after saturation compensation improved from 0.7 ns (0.11 m) to 0.14 ns (0.02 m), which greatly improved the usability of the saturated laser measurement waveform data.

The geometrical measurement precision of laser spots is affected by the deviation between the parameters of the laser altimeter and the laboratory measurement results, and the inversion accuracy of surface object height is also limited. The measurement parameters and the load state can be obtained by calibration of the laser altimeter system. Usually, ground detectors are deployed to calibrate the measurement parameters of the laser altimeter, including the divergence angle and the energy distribution of the laser beam. A calibration method for a laser footprint spot without a calibration field was proposed in this paper, focused on the airborne large-footprint laser altimeter system. The geometric parameters of the laser spot were calibrated through the laser echo waveforms of a specific terrain. The experimental results show that geometric calibration of the large-footprint laser altimeter can be achieved in the area of the step surface. The divergence angle of the laser beams obtained from the six experimental areas is 4.604 ± 0.359 mRad, and the consistency of the energy distribution from each laser spot reaches 92.67%. A new method of on-orbit calibration and verification is provided for the satellite laser altimeter system.