This paper presents a numerical study of the effects of inlet supply starvation on film thickness in EHL point contacts. Generally this problem is treated using the position of the inlet meniscus as the governing parameter; however, it is difficult to measure this in real applications. Thus, in this paper an alternative approach is adopted whereby the amount of oil present on the surfaces is used to define the degree of starvation. It is this property which determines both meniscus position and film thickness reduction. The effect of subsequent overrollings on film thickness decay can also be evaluated. In the simplest case a constant lubricant inlet film thickness in the Y direction is assumed and the film thickness distribution is computed as a function of the oil available. This yields an equation predicting the film thickness reduction, with respect to the fully flooded value, from the amount of lubricant initially available on the surface, as a function of the number of overrollings n. However, the constant inlet film thickness does not give a realistic description of starvation for all conditions. Some experimental studies show that the combination of side flow and replenishment action can generate large differences in local oil supply and that the side reservoirs play an important role in this replenishment mechanism. Thus the contact centre can be fully starved whilst the contact sides remain well lubricated. In these cases, a complete analysis with a realistic inlet distribution has been carried out and the numerical results agree well with experimental findings.
This paper focuses on the lubrication behavior of starved elliptical Elasto-HydroDynamic (EHD) contacts. Starvation is governed by the amount of lubricant available in the inlet region and can result in much thinner films than occurring under fully flooded conditions. Therefore, it would be desirable to be able to predict the onset and severity of starvation and to be able to relate film reduction directly to the operating conditions and lubricant properties. The aim of this work is to explore the influence of these parameters on starvation. A combined modeling and experimental approach has been employed. The numerical model has been developed from an earlier circular contact study [1]. In this model, the amount and distribution of the lubricant in the inlet region determines the onset of starvation and predicts the film decay in the contact. Numerical simulations for a uniform layer on the surface show that a single parameter, characteristic of the inlet length of the contact in the fully flooded regime, determines the starved behavior. Film thickness measurements under starved conditions were performed to validate this theory. For a circular contact excellent agreement was found. In theory the same mechanism applies to elliptic contacts, however, the behavior is more complicated.
This paper investigates the influence of a transverse ridge on the film thickness in a circular EHL contact under rolling/sliding conditions. It is a numerical simulation of the optical EHL work of Kaneta et al. (1992). One of the purposes of this investigation is to check the validity of the algorithm and the Newtonian, isothermal lubricant assumption for film thickness predictions under these conditions (ph = 0.54 GPa). It will be shown that, both quantitatively, the film thickness on the central axis Y = 0, and qualitatively, the film thickness profile through “pseudo interference graphs”, the agreement between experiment and Newtonian isothermal theory is good. This supports the argument that the rheological and the thermal behavior of the fluid only slightly influence the film thickness and pressure distribution of the lightly loaded non-smooth contact case.