ReaxFF reactive force field bridges the gap between nonreactive molecular simulations and quantum mechanical calculations and has been widely applied during the past two decades. However, its application to earth materials, especially those under high T-P conditions relevant to Earth’s interior, is still limited due to the lack of available parameters. Here, we present the development and validation of a ReaxFF force field containing several of the most common elements in Earth’s crust, i.e., Si/Al/O/H/Na/K. The force field was trained against a large data set obtained from density functional theory (DFT) calculations, including charges, bond/angle distortion curves, equation of states, ion migration energy profiles, and condensation reaction energies. Different coordination environments were considered in the training set. The fitting results showed that the current force field can well reproduce the DFT data (the Pearson correlation coefficient, Rp, is 0.95). We validated the force field on mineral–water interfaces, hydrous melts/supercritical geofluids, and bulk crystals. It was found that the current force field performed excellently in predicting the structural, thermodynamic, and transport properties of various systems (Rp = 0.95). Moreover, possible applications and future development have been discussed. The results obtained in this study suggest that the current force field holds good promise to model a wide range of processes and thus open opportunities to advance the application of ReaxFF in earth material modeling.
We report a first principles molecular dynamics (FPMD) study of carboxylate complexation on clay surfaces. By taking acetate as a model carboxylate, we investigate its inner-sphere complexes adsorbed on clay edges (including (010) and (110) surfaces) and in interlayer space. Simulations show that acetate forms stable monodentate complexes on edge surfaces and a bidentate complex with Ca2+ in the interlayer region. The free energy calculations indicate that the complexation on edge surfaces is slightly more stable than in interlayer space. By integrating pKas and desorption free energies of Al coordinated water calculated previously (X. Liu, X. Lu, E. J. Meijer, R. Wang and H. Zhou, Geochim. Cosmochim. Acta, 2012, 81, 56–68; X. Liu, J. Cheng, M. Sprik, X. Lu and R. Wang, Geochim. Cosmochim. Acta, 2014, 140, 410–417), the pH dependence of acetate complexation has been revealed. It shows that acetate forms inner-sphere complexes on (110) in a very limited mildly acidic pH range while it can complex on (010) in the whole common pH range. The results presented in this study form a physical basis for understanding the geochemical processes involving clay–organics interactions.
In order to understand the microscopic properties of alkylammonium-intercalated vermiculites, molecular dynamics simulations employing the clayff-CVFF force field were performed to obtain the interlayer structures and dynamics. The layering behavior of alkyl chains was uncovered. With the model used in the present study (1.2 e per unit cell), the alkyl chains formed monolayers with carbon-chain lengths of C6, bilayers from C7 to C10, and pseudo-trimolecular layers from C15 to C18. Intermediate states also existed between bilayer and pseudo-trimolecular layer states from C11 to C14. The ammonium groups had two locations: most ammonium groups were located over the six-member rings (~90%), and the rest above the substitution sites (~10%). The ammonium groups interacted with the vermiculite surface through H bonds between ammonium H atoms and surface O atoms. The ammonium groups were fixed firmly on surfaces and, therefore, had very low mobility. The alkyl chains were slightly more mobile. The similarities and differences between alkylammonium-intercalated vermiculites and smectites were revealed. The layering behaviors of alkyl chains were similar in alkylammonium-intercalated vermiculites and smectites: the alkyl chain behavior was controlled by both the amount of layer charge and the carbon chain length. The distributions of ammonium groups, however, were different, caused by the layer-charge distribution in vermiculites being different from that in smectites. The atomic-level results derived in the present study will be useful for future research into and the applications of organo-vermiculites.