Near-field focusing properties of zone plates are investigated in the visible regime by a 3-dimensional finite-difference time-domain method. It is shown that Frensel zone plates (FZPs) with metallic coatings can achieve subwavelength focusing in the visible wavelength. The characteristics of subwavelength focusing are found to be independent of the type of metal coatings used. All the FZPs exhibit similar shift in focal length and depth of focus when compared with classical calculations. These results indicate that plasmonic waves do not contribute to subwavelength focusing. Instead the subwavelength focusing characteristic is attributed to the interference of diffracted evanescent waves from a large numerical aperture. It is found that the near-field focusing of FZPs suppresses higher order foci such that the corresponding diffraction efficiency is improved. The use of phase zone plate structured on glass without opaque coating is proposed to improve the diffraction efficiency of subwavelength focusing.
An analytical model is developed to study the subwavelength focusing characteristics of a binary phase Fresnel zone plate (FZP). The model shows that high numerical-aperture phase FZP under the illumination of linear polarized light produces rotationally asymmetric focal spot with beamwidth varying from to , where is the wavelength. On the other hand, rotationally symmetric focal spot with minimum beamwidth of can be obtained from the illumination of radial polarized light.
This article gives classification of micromanufacturing in general and micromachining processes in particular. For different micromachining processes, one can have different kinds of operations through which different features, shapes, accuracy, precision, and dimensions can be achieved. This article as Part I reports an overview of only three processes as diamond turn machining (a class of traditional micromachining processes), electrochemical micromachining, and focused-ion-beam micromachining (a class of advanced micromachining processes). About all these three processes, a brief introduction to the mechanisms of material removal is reported followed by the new developments in each process which are discussed independently. In various sections, some areas where research work needs to be done are identified and very briefly discussed.
Titanium and its alloys have excellent mechanical and chemical properties; however, these properties make the processing of titanium alloys more challenging compared with other engineering materials. Electrochemical micromachining (ECMM) is a non-conventional machining process, which removes material through anodic dissolution regardless of the material’s hardness. However, during the electrochemical machining of titanium, the formation of a passive oxide layer inhibits further material removal and deteriorates the machined surface quality. In addition, the accuracy of micromachining of titanium alloys is especially affected by the formation of electrolysis precipitates such as TiO2 and stray current dissolution. In this study, the effect of the addition of the complexing agent to different electrolytic solutions on the radial overcut during micro-drilling of titanium alloy grade 5 (Ti6Al4V) has been experimentally studied using the in-house developed ECMM set-up. The influence of parameters such as applied voltage and different electrolytic concentration with and without the complexing agent on overcut during ECMM on Ti6Al4V of micro-holes has been studied. It has been safely concluded that the quality of micro-holes fabricated in the presence of EDTA in the electrolyte while machining is responsible for better dimensional characteristics.