Although the thermal conductivity of molten salt mixtures is of interest for many potential technological applications, precise values are often hard to obtain. In this study, the thermal diffusivity of FliNaK was studied in a molten state using the laser flash method and found to be very slightly dependent on temperature. The heat capacity of FliNaK was measured using the DSC method. There was a minor difference between our results and data from the literature. From calculations based on thermal diffusivity, density and heat capacity values, thermal conductivity was shown to decrease with temperature.
The dynamic viscosity (η) of the molten system (NaF-KF)eut-NdF3 containing NdF3 in an amount from 0 to 15 mol.% was studied by rotational viscometry using a high-temperature rheometer, FRS 1600. Viscosity measurements were carried out in the temperature range from liquidus to 1153 K. The measurement procedure was tested on the (LiF-NaF-KF)eut melt. The choice of the parameter shear rate was carried out according to the viscosity and flow curves. Viscosity does not depend on shear rate, and therefore the investigated melts behave like Newtonian fluids, in the range of 9–19 s−1. The experimentally obtained viscosity values for (NaF-KF)eut-NdF3 melts in a wide temperature range are described by an exponential equation. In the coordinates ln(η) = f(1/T), they are straight lines; however, their temperature coefficients are noticeably different, which indicates significant impacts of composition and temperature.
Thermal conductivity and electrical conductivity of borosilicate and alumophosphate glass containing imitators of highly active waste (HAW) from the processing of spent nuclear fuel VVER-440...
5 February 2019 in Journal of Chemical & Engineering Data
The dynamic behavior (formation/dissolution) of the ledge, depending on the electrolyte overheating temperature, thermal resistance of the lining material,