Covalent triazine frameworks (CTFs) are a class of organic polymer materials constructed by aromatic 1,3,5-triazine rings with planar π-conjugation properties. CTFs are highly stable and porous with N atoms in the frameworks, possessing semiconductive properties; thus they are widely used in gas adsorption and separation as well as catalysis. The properties of CTFs strongly depend on the type of monomers and the synthesis process. Synthesis methods including ionothermal polymerization, amino-aldehyde synthesis, trifluoromethanesulfonic acid catalyzed synthesis, and aldehyde-amidine condensation have been intensively studied in recent years. In this review, we discuss the recent advances and future developments of CTFs synthesis.
The electrocatalytic oxygen evolution reaction (OER) presents the key transformation in electrochemical water‐splitting majorly determining energy efficiency and economics of hydrogen generation. In this study, the kinetics of the OER over Ni−Co oxide structured by KIT‐6 templating and non‐structured Ni−Co oxide catalysts in alkaline solution have been investigated aiming for insight with regard to the respective kinetically relevant surface reactions. Steady‐state Tafel plot analysis and electrochemical impedance spectroscopy (EIS) were used to determine kinetic parameters, Tafel slopes and the order of reaction. A dual Tafel slope behavior was observed for both catalysts. Tafel slopes of ca. 40 and 120 mV dec−1 and 90 and 180 mV dec−1 at low and high overpotentials appear for structured and non‐structured Ni−Co oxide, respectively. A reaction order of unity was observed for structured Ni−Co oxide, while non‐structured Ni−Co oxide possessed a fractional reaction order in the high overpotential region. The kinetics of OER over structured Ni−Co oxide were governed by Langmuir adsorption with the rate‐limiting step after primary adsorption of surface intermediates. In contrast, non‐structured Ni−Co oxide obeyed the Temkin adsorption isotherm condition with the primary adsorption step being rate‐limiting.
1 September 2023 in Applied Catalysis B: Environment and Energy
Novel K-promoted bimetallic Fe- and In-based catalysts on a Ce–ZrO2 support were prepared and tested for higher alcohol synthesis from CO2 and hydrogen. The FeIn/Ce–ZrO2 precursors with different Fe contents were characterized in detail, and well-dispersed Fe2O3 and In2O3 phases with oxygen vacancies were observed. The catalysts were tested in a continuous setup at extended times on stream (up to 100 h) at 300 °C, 10 MPa, a gas hourly space velocity of 4500 mL g–1 h–1, and a H2/CO2 ratio of 3. The effect of K loading, the pretreatment atmosphere, Fe/(Fe + In) molar ratios, and calcination temperature on CO2 conversion and product selectivity were studied. Best performance with a CO2 conversion of 29.6% and a higher alcohol selectivity of 28.7%, together with good stability, was obtained over a K-0.82-FeIn/Ce–ZrO2_900 catalyst after activation under a CO atmosphere. These findings were rationalized by considering the effects of the individual catalyst components (K, Fe, and In) on catalyst performance. Surprisingly, the presence of calcined SiC, used as a diluent in the packed bed reactor, was shown to have a positive effect on catalyst performance and as such also is catalytically active. The best performance in terms of higher alcohol yield (8.5%) obtained in this work ranks in the top three of reports on CO2 hydrogenation to higher alcohols in a continuous setup. Moreover, light olefins with 20.3% selectivity (6.0% yield) were coproduced over the optimized catalyst, which has a positive effect on the economic potential of the catalysts.