Manganese (II,III) oxide (Mn3O4) crystalline powder was evaluated as a potential sorbent for removal of arsenic (V) from water. Adsorption isotherm experiments were carried out to determine the adsorption capacity using de-ionized (DI) water, a synthetic solution containing bicarbonate alkalinity, and two natual groundwater samples. Adsorption isotherm data followed the Langmuir and Freundlich equations, indicating favorable adsorption of arsenic (V) onto Mn3O4, while results from the Dubinin–Radushkevich equation were suggestive of chemisorption of arsenic (V). When normalized to the sorbent surface area, the maximum adsorption capacity of Mn3O4 for arsenic (V) was 101 μg m−2, comparable to that of activated alumina. Arsenic (V) adsorption onto Mn3O4 followed pseudo–second-order kinetics. Adsorption of arsenic (V) was greatest at pH 2, while adsorption at pH 7–9 was within 91% of maximum adsorption, whereas adsorption decreased to 32% of maximum adsorption at pH 10. Surface charge analysis confirmed the adsorption of arsenic (V) onto the acidic surface of the Mn3O4 sorbent with a pHPZC of 7.32. The presence of coexisting ions bicarbonate and phosphate resulted in a decrease in arsenic (V) uptake. Comparable adsorption capacities were obtained for the synthetic solution and both groundwater samples. Overall, crystalline Mn3O4 was an effective and viable sorbent for removal of arsenic (V) from natural water, removing greater than 95% of arsenic (V) from a 1 mg L−1 solution within 60 min of contact time.
1 September 2006 in Journal of Environmental Engineering
The removal of 2,4-dinitrotoluene (2,4-DNT), a munitions waste constituent and an industrial intermediate, from contaminated soils was evaluated using enhanced electrokinetic (EK) remediation. Two model soils were spiked with 480 mg of 2,4-DNT/kg of dry soil for the EK experiments. The spiked soils were kaolin, a low-buffering clayey soil, and glacial till, a high-buffering silty soil. The glacial till was obtained from a field site and contained 2.8% organic matter. Deionized (DI) water and cyclodextrin solutions were used as the EK purging solutions. Cyclodextrin was selected as a nonhazardous solubility enhancer for enhancing the desorption and removal of 2,4-DNT from soils in EK remediation. Two aqueous solutions of hydroxypropyl β -cyclodextrin (HPCD) at concentrations of 1 and 2% were selected for kaolin and glacial till, respectively, based on results for batch extraction of 2,4-DNT from the same soils. During the EK experiments, greater current and electro-osmotic flow were observed for HPCD solut...
An aluminum–magnesium–calcium-coated sand (AMCCS) sorbent was evaluated as a low-cost ternary metal oxide adsorbent for adsorption and removal of fluoride from water with potential application in flow-through water filtration systems. The AMCCS sorbent coating contained mostly amorphous oxides of aluminum, magnesium, and calcium. The adsorption of fluoride occurred in less than an hour, while fluoride adsorption followed pseudo-second-order kinetics. The favorable adsorption of fluoride onto the AMCCS sorbent occurred according to the Langmuir and Freundlich adsorption equations, whereas the physical adsorption of fluoride onto the AMCCS sorbent occurred based on the Dubinin–Radushkevich adsorption equation. The adsorption of fluoride occurred over a broad pH range from 2 to 10.5 with a decrease in adsorption at pH above 10.5, indicative of the adsorption of fluoride onto the positively charged surface of AMCCS sorbent at pH below the AMCCS sorbent pHPZC of 10.4. The AMCCS sorbent was able to remove fluoride from natural waters with appreciable alkalinity, total hardness and total dissolved solids, indicative of AMCCS sorbent selectivity for fluoride adsorption. The AMCCS sorbent was re-coated and reused after several adsorption cycles, rendering the AMCCS sorbent a recyclable and sustainable adsorbent for effective and rapid removal of fluoride from water.