We reported on the InGaN p-i-n homojunction solar cells with In contents of 0.02 and 0.12. Under the same illumination of Xe lamp, In0.02 Ga0.98N cell exhibited a fill factor (FF) of 67.8%, a higher open-circuit voltage (Voc) of 2.15 V while In0.12Ga0.88N cell showed a FF of 64.8% and a lower Voc of 1.35 V. The measurements of atomic force microscopy (AFM) images and leakage currents revealed that V-shaped defects, which are known to cause the increase in reverse current, were the main factor dominating the Voc of In0.12Ga0.88N cells. Short-circuit current versus open-circuit voltage (Jsc - Voc) curves were consistent with the characteristics expected from the current-voltage equation. Relative external quantum efficiencies (EQEs) were also measured and showed strong dependence on V-shaped defects. These results indicate that defects in bulk InGaN has a negative impact on the photovoltaic performances of solar cells based on III-nitrides.
The interest in candle soot (CS)-based superhydrophobic coatings has grown rapidly in recent years. Here, a simple and low-cost process has been developed for the fabrication of CS-based superhydrophobic coatings through electrospraying of the composite cocktail solution of CS and polyvinylidene fluoride (PVDF). Results show that the superhydrophobicity of the coating closely relates to the loading amount of CS which results in coatings with different roughnesses. Specifically, increasing the CS amount (not more than 0.4 g) normally enhances the superhydrophobicity of the coating due to higher roughness being presented in the produced microspheres. Further experiments demonstrate that the superhydrophobicity induced in the electrosprayed coating results from the synergistic effect of the cocktail solution and electrospray process, indicating the importance of the coating technique and the solution used. Versatile applications of CS-based superhydrophobic coatings including self-cleaning, anti-corrosion and oil/water separation are demonstrated. The present work provides a convenient method for the fabrication of CS-based superhydrophobic coatings, which is believed to gain great interest in the future.
Effective treatment of frequent oil spills and endless discharged oily wastewater is crucial for the ecosystem and human health. In the past two decades, the collection of oil from water surface has been widely studied through the simple fabrication of superhydrophobic meshes with various coating materials, but little attention is paid to the design aspects of the meshes based oil-collecting device and practical oil collection. Here, 3D-printing devices with different configurations of (super)hydrophobic meshes, circular truncated cone (CTC), cylinder and inverted CTC, and the same inverted cone-shaped structure (below the meshes for temporary oil storage) are investigated. Results demonstrate that the CTC meshes based device especially for an oblate one not only shows higher stability and discharge of the collected oils than previous reports, but also allows floating oils to enter the (super)hydrophobic mesh faster. We anticipate that future success in developing high-performance (super)hydrophobic meshes and the further optimization of the CTC mesh-based device parameters will make our proposed device more practical for the treatment of real-life oil spills.
8 April 2017 in Journal of Materials Science: Materials in Electronics