The objective of this study was to perform a genome-wide association study (GWAS) to detect chromosome regions associated with indicator traits of sexual precocity in Nellore cattle. Data from Nellore animals belonging to farms which participate in the DeltaGen^® and Paint^® animal breeding programs, were used. The traits used in this study were the occurrence of early pregnancy (EP) and scrotal circumference (SC). Data from 72,675 females and 83,911 males with phenotypes were used; of these, 1,770 females and 1,680 males were genotyped. The SNP effects were estimated with a single-step procedure (WssGBLUP) and the observed phenotypes were used as dependent variables. All animals with available genotypes and phenotypes, in addition to those with only phenotypic information, were used. A single-trait animal model was applied to predict breeding values and the solutions of SNP effects were obtained from these breeding values. The results of GWAS are reported as the proportion of variance explained by windows with 150 adjacent SNPs. The 10 windows that explained the highest proportion of variance were identified. The results of this study indicate the polygenic nature of EP and SC, demonstrating that the indicator traits of sexual precocity studied here are probably controlled by many genes, including some of moderate effect. The 10 windows with large effects obtained for EP are located on chromosomes 5, 6, 7, 14, 18, 21 and 27, and together explained 7.91% of the total genetic variance. For SC, these windows are located on chromosomes 4, 8, 11, 13, 14, 19, 22 and 23, explaining 6.78% of total variance. GWAS permitted to identify chromosome regions associated with EP and SC. The identification of these regions contributes to a better understanding and evaluation of these traits, and permits to indicate candidate genes for future investigation of causal mutations.

Animal feeding is the most important economic component of beef production systems. Selection for feed efficiency has not been effective mainly due to difficult and high costs to obtain the phenotypes. The application of genomic selection using SNP can decrease the cost of animal evaluation as well as the generation interval. The objective of this study was to compare methods for genomic evaluation of feed efficiency traits using different cross-validation layouts in an experimental beef cattle population genotyped for a high-density SNP panel (BovineHD BeadChip assay 700k, Illumina Inc., San Diego, CA). After quality control, a total of 437,197 SNP genotypes were available for 761 Nelore animals from the Institute of Animal Science, Sertãozinho, São Paulo, Brazil. The studied traits were residual feed intake, feed conversion ratio, ADG, and DMI. Methods of analysis were traditional BLUP, single-step genomic BLUP (ssGBLUP), genomic BLUP (GBLUP), and a Bayesian regression method (BayesCπ). Direct genomic values (DGV) from the last 2 methods were compared directly or in an index that combines DGV with parent average. Three cross-validation approaches were used to validate the models: 1) YOUNG, in which the partition into training and testing sets was based on year of birth and testing animals were born after 2010; 2) UNREL, in which the data set was split into 3 less related subsets and the validation was done in each subset a time; and 3) RANDOM, in which the data set was randomly divided into 4 subsets (considering the contemporary groups) and the validation was done in each subset at a time. On average, the RANDOM design provided the most accurate predictions. Average accuracies ranged from 0.10 to 0.58 using BLUP, from 0.09 to 0.48 using GBLUP, from 0.06 to 0.49 using BayesCπ, and from 0.22 to 0.49 using ssGBLUP. The most accurate and consistent predictions were obtained using ssGBLUP for all analyzed traits. The ssGBLUP seems to be more suitable to obtain genomic predictions for feed efficiency traits on an experimental population of genotyped animals.

The objective of this study was to evaluate the accuracy of genomic predictions for rib eye area (REA), backfat thickness (BFT), and hot carcass weight (HCW) in Nellore beef cattle from Brazilian commercial herds using different prediction models. Phenotypic data from 1756 Nellore steers from ten commercial herds in Brazil were used. Animals were offspring of 294 sires and 1546 dams, reared on pasture, feedlot finished, and slaughtered at approximately 2 years of age. All animals were genotyped using a 777k Illumina Bovine HD SNP chip. Accuracy of genomic predictions of breeding values was evaluated by using a 5-fold cross-validation scheme and considering three models: Bayesian ridge regression (BRR), Bayes C (BC) and Bayesian Lasso (BL), and two types of response variables: traditional estimated breeding value (EBV), and phenotype adjusted for fixed effects (Y*). The prediction accuracies achieved with the BRR model were equal to 0.25 (BFT), 0.33 (HCW) and 0.36 (REA) when EBV was used as response variable, and 0.21 (BFT), 0.37 (HCW) and 0.46 (REA) when using Y*. Results obtained with the BC and BL models were similar. Accuracies increased for traits with a higher heritability, and using Y* instead of EBV as response variable resulted in higher accuracy when heritability was higher. Our results indicate that the accuracy of genomic prediction of carcass traits in Nellore cattle is moderate to high. Prediction of genomic breeding values from adjusted phenotypes Y* was more accurate than from EBV, especially for highly heritable traits. The three models considered (BRR, BC and BL) led to similar predictive abilities and, thus, either one could be used to implement genomic prediction for carcass traits in Nellore cattle.

Carcass traits measured after slaughter are economically relevant traits in beef cattle. In general, the slaughter house payment system is based on HCW. Ribeye area (REA) is associated with the amount of the meat in the carcass, and a minimum of backfat thickness (BFT) is necessary to protect the carcass during cooling. The aim of this study was to identify potential genomic regions harboring candidate genes affecting those traits in Nellore cattle. The data set used in the present study consisted of 1,756 Nellore males with phenotype records. A subset of 1,604 animals had both genotypic and phenotypic information. Genotypes were generated based on a panel with 777,962 SNPs from the Illumina Bovine HD chip. The SNP effects were calculated based on the genomic breeding values obtained by using the single-step GBLUP approach and a genomic matrix re-weighting procedure. The proportion of the variance explained by moving windows of 100 consecutive SNPs was used to assess potential genomic regions harboring genes with major effects on each trait. The top 10 non-overlapping SNP-windows explained 8.72%, 11.38%, and 9.31% of the genetic variance for REA, BFT, and HCW, respectively. These windows are located on chromosomes 5, 7, 8, 10, 12, 20, and 29 for REA; chromosomes 6, 8, 10, 13, 16, 17, 18, and 24 for BFT; and chromosomes 4, 6, 7, 8, 14, 16, 17, and 21 for HCW. For REA, there were identified genes (CDKN2A and CDKN2B) involved in the cell cycle biological process which affects many aspects of animal growth and development. The SLC38A1 and SLC38A2 genes, both from SLC38 AA transporter family, was also associated with REA. The AA transporters are essential for cell growth and proliferation, acting as carriers of tissue nutrient supplies. Various genes identified for BFT (SORCS2, AQP3, AQP7, CDC42BPA, ASIP, and ACSS2) have been associated with lipid metabolism in different mammal species. One of the most promising genes identified for HCW was the PLAG1. There is evidence, in the literature, that this gene is located in putative QTL affecting carcass weight in beef cattle. Our results showed several genomic regions containing plausible candidate genes that may be associated with carcass traits in Nellore cattle. Besides contributing to a better understanding of the genetic control of carcass traits, the identified genes can also be helpful for further functional genomic studies.

The aim of this study was to estimate genetic and phenotypic associations of growth traits with carcass and meat traits in Nellore cattle. Data from male and female animals were used for weaning weight (WW; N = 241,416), yearling weight (YW, N = 126,596), weight gain from weaning to yearling (GWY, N = 78,687), and yearling hip height (YHH, N = 90,720), respectively; 877 male animals were used for hot carcass weight (HCW) and 884 for longissimus muscle area (LMA), backfat thickness (BT), marbling score (MS), and shear force (SF). The variance components were estimated by the restricted maximum likelihood method using three-trait animal models that included WW. The model for WW included direct and maternal additive genetic, maternal permanent environmental, and residual effects as random effects; contemporary group as fixed effects; and age of dam at calving and age of animal as covariates (linear and quadratic effects). For the other traits, maternal effects and the effect of age of dam at calving were excluded from the model. Heritability ranged from 0.10 ± 0.12 (LMA) to 0.44 ± 0.007 (YW). Genetic correlations ranged from -0.40 ± 0.38 (WW x LMA) to 0.55 ± 0.10 (HCW x YW). Growth, carcass, and meat traits have sufficient genetic variability to be included as selection criteria in animal breeding programs.