To study the dynamic mechanical characteristics and constitutive relation of concrete materials under freeze–thaw (FT) cycle conditions, C35 concrete was taken as the research object in this paper, and FT tests were carried out with a freeze–thaw range of −20–20 °C and a freeze–thaw frequency up to 50 times. By using the separated Hopkinson pressure bar (SHPB) system, impact compression tests of concrete specimens under different FT cycle actions were developed, then the dynamic fracture morphology, fracture block distribution, stress–strain curve, peak stress and other dynamic mechanical properties of concrete were analyzed, and the influence law of FT action and strain rate was obtained. Through introducing the freeze–thaw deterioration damage factor and the stress damage variable, the dynamic visco-elastic damage constitutive equation of freeze–thawed concrete was constructed based on component combination theory. Furthermore, the damage evolution process and mechanism of freeze–thawed concrete materials were revealed. The research results show that the dynamic mechanical properties of concrete under a freeze–thaw environment are the combined results of the freeze–thaw deterioration effect and the strain rate strengthening effect. The dynamic visco-elastic damage constitutive model established in this paper can effectively describe the dynamic mechanical properties of freeze–thawed concrete, and has the characteristics of few parameters and good effect. The stress damage evolution path of concrete goes backward with the increase of FT cycles and the development speed gradually slows down. The greater the difference in FT cycles, the greater the difference in stress damage path.
To provide theoretical basis for fire rescue, post-disaster safety evaluation, and reinforcement of concrete structures, C35 concrete materials are treated with high-temperature heating (200 °C, 400 °C, 600 °C, 800 °C) under two different heating gradients. After natural cooling and water cooling to normal temperature, an impact compression test was carried out at different loading rates using a Split Hopkinson Pressure Bar (SHPB) system with a diameter of 100 mm, and finally the crushed specimens were subjected to a sieving test. The effects of elevated temperatures, cooling methods, heating gradients, and loading rates on the fragment size distribution, fractal characteristics, and energy dissipation of impact-compressed concrete specimens were studied. The results show that with the increase of the loading rate and the rise of the heating temperature, the crushing degree of concrete specimens gradually increases, the average fragment size decreases, and the mass distribution of the fragments move from the coarse end to the fine end. The fragment size distribution of the specimen has obvious fractal characteristics. In addition, its fractal dimension increases with the increase of loading rate and heating temperature, the average size of the specimen fragments decreases correspondingly, and the fracture of the specimen becomes more serious. When the different heating gradients were compared, it was found that the fractal dimension of the specimens subjected to rapid heating treatment was larger than that of the slow heating treatment specimens, and the crushing degree of the specimens with different cooling methods was discrete. By analyzing the energy dissipation of the specimen under different conditions, it is shown that both the fractal dimension and the peak stress increase with the increase of the fragmentation energy dissipation density. It shows that there is a close correlation between the change of fractal dimension and its macroscopic dynamic mechanical properties.
29 March 2023 in International Journal of Green Energy
In this study, experiments were performed to investigate the cooling effect of liquid immersion cooling based on SF33 for 8 Ah prismatic lithium-ion battery. First, the cell temperature variations under high C rates discharging with natural convection and liquid immersion cooling were compared. The results reveal that liquid immersion cooling has good cooling performance and can limit the maximum temperature of the cell to be below 33.25°C and 35°C even under ultra-fast discharging for 5C and 8C. Then, the effects of cell spacing and liquid filling levels were explored. The cell spacing has less effect on the cooling performance. Meanwhile, the influence of liquid filling level on the cell temperature and temperature uniformity is found to be significant. Finally, the two-phase heat transfer phenomenon of liquid immersion cooling was observed and recorded to investigate the mechanisms for the shifting from single phase natural convection to two-phase boiling heat transfer.