Synchronization of high-frequency chaotic optical pulses is demonstrated in two semiconductor lasers with delayed optoelectronic feedback. The difference between synchronization and modulation is discussed. Evidence is presented to show that true synchronization, rather than modulation or amplification, is accomplished in our optoelectronic feedback system.
The optical conductivity of monolayer and multilayer graphene in the terahertz spectral region is experimentally measured using terahertz time-domain spectroscopy. The stacking arrangement and the misorientation angle of each sample are determined by Raman spectroscopy. The chemical potential of each sample is measured using ultrafast midinfrared pump-probe spectroscopy to be 63 or 64 meV for all samples. The intraband scattering rate can be obtained by fitting the measured data with theoretical models. Other physical parameters, including carrier density, dc conductivity, and carrier mobility, of each sample can also be deduced from the theoretical fitting. The fitting results show the existence of misoriented or AA-stacked layers with an interaction energy of $\alpha${}1=217meV in our multilayer samples. Here we show that the scattering rate strongly depends on the stacking arrangement of the sample. High scattering rates and high optical conductivity are associated with AA-stacked samples, while lower ones are associated with misoriented multilayer graphene. This implies that the THz optoelectronic properties of multilayer graphene can be tuned by purposefully misorienting layers or employing different stacking schemes.
1 January 2014 in Nanomaterials and Nanotechnology
With strong spin-orbit coupling, topological insulators have an insulating bulk state, characterized by a band gap, and a conducting surface state, characterized by a Dirac cone. Plasmons in topological insulators show high frequency-tunability in the mid-infrared and terahertz spectral regions with transverse spin oscillations, also called “spin-plasmons”. This paper presents a discussion and review of the developments in this field from the fundamental theory of plasmons in bulk, thin-film, and surface-magnetized topological insulators to the techniques of plasmon excitation and future applications.
11 April 2010 in IEEE Journal of Quantum Electronics
Transmission properties of data amplitude modulation (AM) and frequency modulation (FM) in radio-over-fiber (RoF) system are studied numerically. The influences of fiber dispersion and nonlinearity on different microwave modulation schemes, including double side band (DSB), single side band (SSB) and optical carrier suppression (OCS), are investigated and compared. The power penalties at the base station (BS) and the eye opening penalties of the recovered data at the end users are both calculated and analyzed. Numerical simulation results reveal that the power penalty of FM can be drastically decreased due to the larger modulation depth it can achieve than that of AM. The local spectrum broadening around subcarrier microwave frequency of AM due to fiber nonlinearity can also be eliminated with FM. It is demonstrated for the first time that the eye openings of the FM recovered data can be controlled by its modulation depths and the coding formats. Negative voltage encoding format was used to further decrease the RF frequency thus increase the fluctuation period considering their inverse relationship.
We demonstrated an all-fiber, high-power noise-like pulse laser system at the 1.56-µm wavelength. A low-power noise-like pulse train generated by a ring oscillator was amplified using a two-stage amplifier, where the performance of the second-stage amplifier determined the final output power level. The optical intensity in the second-stage amplifier was managed well to avoid not only the excessive spectral broadening induced by nonlinearities but also any damage to the device. On the other hand, the power conversion efficiency of the amplifier was optimized through proper control of its pump wavelength. The pump wavelength determines the pump absorption and therefore the power conversion efficiency of the gain fiber. Through this approach, the average power of the noise-like pulse train was amplified considerably to an output of 13.1 W, resulting in a power conversion efficiency of 36.1% and a pulse energy of 0.85 µJ. To the best of our knowledge, these amplified pulses have the highest average power and pulse energy for noise-like pulses in the 1.56-µm wavelength region. As a result, the net gain in the cascaded amplifier reached 30 dB. With peak and pedestal widths of 168 fs and 61.3 ps, respectively, for the amplified pulses, the pedestal-to-peak intensity ratio of the autocorrelation trace remains at the value of 0.5 required for truly noise-like pulses.
The terahertz plasmon dispersion of a multilayer system consisting of graphene on dielectric and/or plasma thin layers is systematically investigated. We show that graphene plasmons can couple with other quasiparticles such as phonons and plasmons of the substrate; the characteristics of the plasmon dispersion of graphene are dramatically modified by the presence of the coupling effect. The resultant plasmon dispersion of the multilayer system is a strong function of the physical parameters of the spacer and the substrate, signifying the importance of the substrate selection in constructing graphene-based plasmonic devices.