Polyoxometalates (POMs) are promising inorganic inhibitors for P-type ATPases. The experimental models used to study the effects of POMs on these ATPases are usually in vitro models using vesicles from several membrane sources. Very recently, some polyoxotungstates, such as the Dawson anion [P2W18O62]6-, were shown to be potent P-type ATPase inhibitors; being active in vitro as well as in ex-vivo. In the present study we broaden the spectrum of highly active inhibitors of Na+/K+-ATPase from basal membrane of epithelial skin to the bi-capped Keggin-type anion phosphotetradecavanadate Cs5.6H3.4PV14O42 (PV14) and we confront the data with activity of other commonly encountered polyoxovanadates, decavanadate (V10) and monovanadate (V1). The X-ray crystal structure of PV14 was solved and contains two trans-bicapped α-Keggin anions HxPV14O42(9-x)-. The anion is built up from the classical Keggin structure [(PO4)@(V12O36)] capped by two [VO] units. PV14 (10 μM) exhibited higher ex-vivo inhibitory effect on Na+/K+-ATPase (78%) than was observed at the same concentrations of V10 (66%) or V1 (33%). Moreover, PV14 is also a potent in vitro inhibitor of the Ca2+-ATPase activity (IC50 5 μM) exhibiting stronger inhibition than the previously reported activities for V10 (15 μM) and V1 (80 μM). Putting it all together, when compared both P-typye ATPases it is suggested that PV14 exibited a high potential to act as an in vivo inhibitor of the Na+/K+-ATPase associated with chloride secretion.

The demand for energy storage supercapacitor devices has increased interest in completing all innovative technologies and renewable energy requirements. Here, we report a simple method of two polyoxomolybdate (H₄[PVMo₁₁O₄₀] and H₅[PV₂Mo₁₀O₄₀]) doped polyindole (PIn) composites for electrochemical supercapacitors. The interactions between polyoxomolybdates and PIn were measured by Fourier transform infrared spectroscopy (FTIR), and powder XRD, and stability was measured by thermogravimetry. The field emission scanning microscopy (FESEM) was employed to investigate the morphology of the materials. The electrochemical measurements show that the PIn/PV₂Mo₁₀ electrode exhibits a higher capacitance of 198.09 F/g with an energy density of 10.19 Wh/kg and a power density of 198.54 W/kg at 0.2 A/g current density than the PIn/PVMo₁₁ electrode. Both electrodes show a pseudocapacitance behavior due to the doping of redox-active polyoxomolybdates on the PIn surface and enhance the electrochemical properties. The electrodes’ capacitive nature was measured by electrochemical impedance spectroscopy (EIS), which shows that the PIn/PVMo₁₁ electrode has a resistive nature within the electrode–electrode interface. Moreover, the PIn/PV₂Mo₁₀ electrode offers remarkable cycle stability, retaining ∼84% of its capacitance after 10,000 cycles (∼83% for the PIn/PVMo₁₁ electrode). The higher specific capacitance, faster charge/discharge rates, and higher cycle stability make them promising electrodes in supercapacitors.

Polyoxovanadates were recently found to be the most active among a series of polyoxometalates against bacteria. In this study, a reverse correlation was found between the Ca²⁺-ATPase IC₅₀and theE. ColiGI₅₀values.

Thermoplastic starch (TPS), derived from renewable resources, offers advantages such as biodegradability and lower production costs compared to petroleum-based plastics. However, its limited mechanical properties pose a challenge for broader applications. This research aims to explore the potential of enhancing the mechanical and barrier properties of TPS films through the incorporation of silicon dioxide as a reinforcement filler and citric acid as a crosslinking agent. By introducing silicon dioxide as a reinforcement filler, the mechanical strength of the TPS films is expected to be improved. Additionally, the incorporation of citric acid as a crosslinking agent is anticipated to enhance the barrier properties of the films. The combination of these additives holds promise for creating TPS films with improved performance, contributing to the development of sustainable and environmentally friendly materials in various industries. The results reveal that SiO₂ improves the stiffness of the films at lower concentrations but causes brittleness at higher concentrations. In contrast, citric acid crosslinked films exhibit improved flexibility and density. Scanning electron microscopy demonstrates the morphological changes in the films, with SiO₂ affecting surface roughness and aggregate formation. SiO₂ reduces film thickness and transparency, while citric acid enhances water resistance and barrier properties. X-ray diffraction analysis shows a reduction in crystallinity due to the plasticization process. Fourier-transform infrared spectroscopy highlights chemical changes and antimicrobial activity is observed with citric acid against specific bacteria. The soil burial test reveals that citric acid crosslinked films exhibit slower degradation due to antimicrobial properties. The combination of SiO₂ reinforcement and citric acid crosslinking enhances the overall performance of the films, promising sustainable and environmentally friendly materials for various applications.