The aim of this paper is to analyze the mechanical properties of Robinia pseudoacacia L. (black locust), Platanus × hybrida Brot. (London plane), Ulmus pumila L. (Siberian elm), and Populus alba L. (white poplar), estimated using ultrasound wave equipment (USLab y Sylvatest Duo) and impact wave equipment (Microsecond Timer) on standing trees, felled logs and on specimens obtained from different parts of the trees. Bending strength, axial compression strength and tension parallel to grain were determined for each specimen, in order to subsequently correlate the strength and stiffness with the acoustic properties determined in the standing tree. For the relationship between the static modulus of elasticity of the specimens and the dynamic modulus of elasticity determined in standing trees using the USLab, coefficients of determination were found to be between 0.30–0.92, between 0.52 and 0.80 using the Sylvatest Duo and between 0.60 and 0.94 with the Microsecond Timer. It would be necessary to determine whether the removal of bark for the correct coupling of the ultrasonic sensors would provide an entry route for pests or diseases that could affect the health of the tree.
Acoustic tomography is a non-destructive technique used in the internal assessment of standing trees. Various researchers have focused on developing analytical tools using this technique, demonstrating that they can detect internal biodeterioration in cross-sections with good accuracy. This study evaluates the use of two ultrasonic wave devices with different frequencies (USLab and Sylvatest Duo) and a stress wave device (Microsecond Timer) to generate acoustic tomography using ImageWood VC1 software. The tests were carried out on 12 cross-sections of urban trees in the city of Madrid of the species Robinia pseudoacacia L., Platanus × hybrida Brot., Ulmus pumila L., and Populus alba L. Velocity measurements were made, forming a diffraction mesh in both standing trees and logs after cutting them down. An inspection was carried out with a perforation resistance drill (IML RESI F-400S) in the radial direction in each section, which allowed for more precise identification of defects and differentiating between holes and cracks. The various defects were determined with greater accuracy in the tomographic images taken with the higher-frequency equipment (45 kHz), and the combination of ultrasonic tomography and the use of the inspection drill can provide a more accurate representation of the defects.