We have proposed a high sensitive photonic crystal fiber (PCF) strain sensor based on the Mach-Zehnder interferometer (MZI). The sensing head is formed by all-fiber in-line single mode-multimode-photonic-crystal-single mode fiber (SMPS) structure, using only the splicing method. Such a strain sensor exhibited a high sensitivity of −2.21 pm/με within a large measurement range of up to 5000 με and a large fringe visibility of up to 24 dB. Moreover, it was found that the strain sensitivity was weekly dependent of the length of PCF or MMF. In addition, the sensor exhibited the advantages of simplicity of fabrication, high sensitivity and larger fringe visibility.

We demonstrated a fiber in-line Mach-Zehnder interferometer (MZI) coated with platinum (Pt) for the simultaneous measurement of strain and temperature. The sensor was fabricated by splicing a section of multimode fiber (MMF) between two single mode fibers (SMFs) and the Pt coating was prepared by iron sputtering technology. Fine interference fringes of over 20 dB with a compact size of 20 mm were achieved. The experimental results of the two different resonant dips showed strain sensitivities of −2.06 pm/με and −2.21 pm/με, as well as temperature sensitivities of 55.2 pm/°C and 53.4 pm/°C, respectively. Furthermore, it was found that the Pt coating can improve the strain sensitivity significantly, resulting in an increase of about 54.5%. In addition, the sensor has advantages of easy fabrication, low cost, and high sensitivity, showing great potential for the dual-parameter sensing of strain and temperature.

In order to improve the performance of silver nanowire (AgNW) flexible transparent conductive films (FTCFs), including the conductivity, uniformity, and reliability, the welding of high repetition rate femtosecond (fs) laser is applied in this work. Fs laser irradiation can produce local enhancement of electric field, which induce melting at the gap of the AgNWs and enhance electrical conductivity of nanowire networks. The overall resistivity of the laser-welded AgNW FTCFs reduced significantly and the transparency changed slightly. Meanwhile, PET substrates were not damaged during the laser welding procedure in particular parameters. The AgNW FTCFs can achieve a nonuniformity factor of the sheet resistance as 4.6% at an average sheet resistance of 16.1 Ω/sq and transmittance of 91%. The laser-welded AgNW FTCFs also exhibited excellent reliability against mechanical bending over 10,000 cycles. The welding process may open up a new approach for improvement of FTCFs photoelectric property and can be applied in the fabrication of silver nanostructures for flexible optoelectronic and integration of functional devices.

The eigenfrequency of a resonator plays a significant role in the operation of a cylindrical shell vibrating gyroscope, and trimming is aimed at eliminating the frequency split that is the difference of eigenfrequency between two work modes. In this paper, the effects on eigenfrequency under resonator-top trimming methods that trim the top of the resonator wall are investigated by simulation and experiments. Simulation results show that the eigenfrequency of the trimmed mode increases in the holes-trimming method, whereas it decreases in the grooves-trimming method. At the same time, the untrimmed modes decrease in both holes-trimming and grooves-trimming methods. Moreover, grooves-trimming is more efficient than holes-trimming, which indicates that grooves-trimming can be a primary trimming method, and holes-trimming can be a precision trimming method. The rigidity condition after grooves-trimming is also studied to explain the variation of eigenfrequency. A femtosecond laser is employed in the resonator trimming experiment by the precise ablation of the material. Experimental results are in agreement with the simulation results.